PILKÅN Faucet Assembly Instructions

Contents

• Tools and spare parts
• Illustration of product, parts and part numbers
• Product assembly

Important Information

Installation Warning: Installation shall be carried out in accordance with Industry Regulations Säker Vatteninstallation.

Safety Note: Switch off the main shut-off valve before changing the mixer tap.

Certification: Accepted assembly instructions, TG 1527, 1913, EN 817 | EN 1717. RSK No: 8275789.

Tools and Spare Parts

The following parts are included:

• 1x Threaded rod (Part No. 120143)
• 1x Nut (Part No. 120172)
• 1x Allen key (Part No. 110084)
• 2x Mounting plates (Part Nos. 120142, 120141)

Tools required (not included):

• Silicone sealant (water- and mould-resistant, suitable for installation according to EN 15651-3, Class XS1)
• Coin (for unscrewing aerator)
• Wrench

Product Assembly

Step 1:

The faucet is shown with the threaded rod (120143) inserted through the mounting hole.

Step 2:

Seal the open surfaces with silicone to prevent water from penetrating the worktop upon any leaks. Ensure the silicone sealant is water- and mould-resistant and suitable for the installation, according to EN 15651-3, Class XS1.

The hole in the worktop should be between 34-37 mm (1 3/8" - 1 1/2") in diameter.

The maximum thickness of the worktop is 50 mm (2").

Parts used in this step: 120141, 120142, 126908 (silicone gun), 120172.

Step 3:

Attach the faucet to the worktop using the provided parts. Ensure the pipe connection is flat and free from sharp edges. Use a wrench to tighten the nut.

IMPORTANT: Do not overtighten. This can damage hoses/pipes and washers.

Step 4:

Before use: Unscrew the Aerator/Flow Guide with a coin and allow the water to run freely for a few minutes. Then screw the Aerator/Flow Guide back in place up to the stop. DO NOT OVERTIGHTEN.

Step 5:

Check at regular intervals to make sure that the installation is not leaking.

Operating Conditions:

• Recommended Operating temperature: Max. 60°C
• Recommended Operating Pressure: 1-5 bar
• Maximum Operating Temperature: Max. 80°C
• Maximum Operating Pressure: 0,5-10 bar

Troubleshooting

If the faucet is leaking, check all connections and ensure they are properly tightened. If the water flow is weak, unscrew and clean the aerator.