POWERSHRED 325Ci/325i

Please read these instructions before use. Keep for future reference. Quality Office Products Since 1917.

Product Capabilities

Will shred: Paper, credit cards, CD/DVD, staples, small paper clips, and junk mail.

Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, cardboard, large paper clips, folders, X-rays, or plastic other than noted above.

Shred Size

• 325Ci: Cross-Cut (4mm x 38mm)
• 325i: Strip Cut (5.8mm)

Maximum Performance

• Sheets per pass (Cross-Cut): 22*
• Sheets per pass (Strip-Cut): 24*
• CDs/Cards per pass: 1*
• Paper entry width: 9.5 in. (240mm)

*Based on 8.5"x11", 20lb. (75g) paper at 120V, 60 Hz, 8 Amps. Heavier paper, humidity, or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 8,000 sheets; 300 cards; 30 CDs.

Operating Environment

• Temperature: 50–80°F (10–26°C)
• Humidity: 40–80% relative humidity

Important Safety Instructions -- Read Before Using!

• Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set to OFF (?) or unplug when not in use.
• Keep foreign objects (gloves, jewelry, clothing, hair, etc.) away from shredder openings. If an object enters the top opening, switch to Reverse (◀️) to back out the object.
• Never use aerosol products, petroleum-based lubricants, or other flammable products on or near the shredder. Do not use canned air on the shredder.
• Do not use if damaged or defective. Do not disassemble the shredder. Do not place near or over a heat source or water.
• This shredder has a Disconnect Power Switch (F) that must be in the ON (?) position to operate. In case of emergency, move the switch to OFF (?). This action will stop the shredder immediately.
• Avoid touching exposed cutting blades under the shredder head.
• Use only the designated entry for CDs/cards. Keep fingers away from the CD entry.
• Do not put foreign objects in the paper entry.
• The shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug the shredder before cleaning or servicing.

Basic Shredding Operation

1. Plug in the shredder and set the disconnect power switch to the ON (?) position.
2. Press the ON (?) button on the control panel to activate the shredder.
3. Feed paper or cards straight into the paper entry and release.
4. For CDs/cards: Hold by the edge and feed into the center of the entry, then release.
5. When finished shredding, set the control panel to OFF (?).
6. The shredder will automatically enter sleep mode after 2 minutes of inactivity.

Advanced Product Features

Jam Proof System

Eliminates paper jams and powers through tough jobs.

Jam Proof System Operation

1. Advanced Jam Prevention: The shredder electronically measures paper thickness.
   • RED Indicator: Too many sheets have been inserted.
   • YELLOW Indicator: Productivity is optimized.
   • GREEN Indicator: More sheets can be added.
2. If a misfeed occurs: All indicators will light up, and the shredder will pause for 3-6 seconds. Remove several sheets until the indicator is below the red zone. Wait for flashing to stop; regular shredding will resume.
3. If the [remove-paper-icon] indicator illuminates after paper has been reversed, press the reverse button (◀️) and remove the paper. Otherwise, regular shredding will resume automatically.

SafeSense® Technology

Stops shredding immediately when hands touch the paper entry.

SafeSense® Technology Operation

1. Turn the shredder ON (?) to activate SafeSense®.
2. Touch the designated test area. The SafeSense® indicator (?) should illuminate, confirming it is active and working properly.
3. If a hand is held on the SafeSense® area for more than 3 seconds, the shredder will automatically shut off.

Energy Savings System

Optimal energy efficiency 100% of the time – in use and out of use. Saves energy in four ways: energy-efficient electronics, jam prevention, standby mode, and sleep mode.

Sleep Mode: Shuts down the shredder after 2 minutes of inactivity.

To exit sleep mode: Touch the control panel or insert paper.

Product Maintenance

Cleaning Auto-Start Infrared Sensors

Paper detection sensors are designed for maintenance-free operation. However, on rare occasions, they may become blocked by paper dust, causing the motor to run even when no paper is present. (Note: two paper detection sensors are located in the center of the paper entry).

To Clean the Sensors:

1. Turn off and unplug the shredder.
2. Locate the auto-start infrared sensor(s) in the center of the paper entry.
3. Dip a cotton swab in rubbing alcohol.
4. Using the cotton swab, gently wipe away any contamination from the paper sensors.

Oiling Shredder

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, it is recommended to oil your shredder each time you empty the waste bin.

Follow Oiling Procedure Below and Repeat Twice:

1. Apply oil across the paper entry.
2. Press and hold the forward button (➡️) for 2-3 seconds.

Note: Only use a non-aerosol vegetable oil in a long nozzle container, such as Fellowes 35250.

Troubleshooting Indicators

• Bin Full Indicator (?️): When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36056.
• SafeSense® Indicator (?): If hands are too close to the paper entry, the SafeSense® indicator will illuminate, and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off, and the user must press the power button on the control panel to resume shredding.
• Remove Paper Indicator: When illuminated, press reverse (◀️) and remove paper. Reduce paper quantity to an acceptable amount and refeed into the paper entry.
• Door Open Indicator (?): The shredder will not run if the cabinet door is open. When illuminated, close the door to resume shredding.
• Straight Feed Indicator: When illuminated, remove paper and feed straight into the paper entry.

Limited Product Warranty

Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for the lifetime of the shredder. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact Fellowes or your dealer.

Questions or Concerns?

Customer Service & Support

Website: www.fellowes.com

• Troubleshooting
• Registration
• Manuals
• Replacement parts
• General questions

Phone Numbers:

• Canada: +1-800-665-4339
• Mexico: +001-800-514-9057
• United States: +1-800-955-0959

Fellowes, Inc.
1789 Norwood Avenue, Itasca, Illinois 60143-1095 USA
Phone: 630-893-1600

©2012 Fellowes, Inc. Part No. 406973 Rev B