Fellowes POWERSHRED 99Ci
THE WORLD'S TOUGHEST SHREDDERS™
Please read these instructions before use. Do not discard: keep for future reference.
Quality Office Products Since 1917
Key Components and Controls
Diagram of shredder with labels A-H:
- A. SafeSense® Technology
- B. Paper entry
- C. Safety instructions
- D. CD/Card safety flap
- E. Pullout bin
- F. Casters
- G. Disconnect power switch (1. OFF, 2. ON)
- H. Control Panel and LEDs:
- 1. Overheat (red ?)
- 2. Bin open (red ?)
- 3. Bin full (red ?)
- 4. Remove Paper (red ?)
- 5. SafeSense® indicator (yellow ?)
- 6. Sheet capacity indicator
- 7. Auto (blue ?)
- 8. Reverse (◀◀)
- 9. ON/OFF (blue ?)
- 10. Forward (▶)
Capabilities
- Will shred: Paper, credit cards, CD/DVDs, staples, and small paper clips.
- Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays, or plastic other than noted above.
Paper shred size: Cross-Cut - 5/32" x 1-1/2" (3.9 x 38mm)
Maximums:
| Item | Capacity |
|---|---|
| Sheets per pass* | 17 |
| CDs/Cards per pass* | 1 |
| Paper entry width | 9" / 230mm |
*Based on 8.5"x11", 20lb. (75g) paper at 120V, 60 Hz, 5Amps. Heavier paper, humidity, or other than rated voltage may reduce capacity.
Recommended daily usage rates: 1500 sheets per day, 50 credit cards; 10 CDs.
Fellowes SafeSense® shredders are designed for operation in environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
- Keep away from children and pets. Keep hands away from paper entry. Always set to OFF (0) or unplug when not in use. ?
- Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If an object enters the top opening, switch to Reverse (◀◀) to back out the object. ?
- Never use aerosol products, petroleum-based lubricants, or other flammable products on or near the shredder. Do not use canned air on the shredder. ?
- Do not use if damaged or defective. Do not disassemble the shredder. Do not place near or over a heat source or water. ⚠️
- Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating the shredder. ?
- This shredder has a Disconnect Power Switch (G) that must be in the ON (I) position to operate. In case of emergency, move the switch to OFF (0) position. This action will stop the shredder immediately. ⚡
- Avoid touching exposed cutting blades under the shredder head. ?
- The shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product. ?
- FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries. ?
- For indoor use only. ?
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Basic Set Up - Caster Installation
Follow these steps to install the casters:
- Align a caster with the wheel housing.
- Push the caster firmly into the wheel housing.
- Repeat for all four casters.
- Turn the shredder upright onto the installed casters.
- Ensure the shredder is stable on its casters.
Basic Shredding Operation
Continuous operation: 25-minute maximum. The shredder runs briefly after each pass to clear the entry. Continuous operation beyond 25 minutes will trigger a 40-minute cool-down period.
Paper or CD/Card Shredding Steps:
- Plug in the shredder and set the disconnect power switch (G) to ON (I).
- Press the ON/OFF button (blue ?) to activate the shredder.
- Feed paper straight into the paper entry and release.
- To shred CDs or credit cards: Rotate the safety flap into place. Hold the card/CD at the edge and feed it into the center of the entry, then release.
- When finished shredding, set the power switch to OFF ( ).
Advanced Product Features
- Jam Proof System: Eliminates jams and powers through tough jobs. ?
- Patented SafeSense® Technology: Stops shredding immediately when hands touch the paper opening. ✋
- SilentShred™ Technology: Provides quiet operation without noisy disruptions. ?
100% Jam Proof System Operation*
The system electronically measures paper thickness to prevent paper jams.
- Indicator Lights:
- RED ?: Too Many sheets have been inserted.
- YELLOW ?: Productivity is optimized.
- GREEN ?: More sheets can be added.
- If a misfeed occurs: All indicators light up, and the shredder pauses for 3-6 seconds.
- Correction: Remove several sheets until the indicator is below red. Wait for flashing to stop after automatic correction is complete; regular shredding will resume.
*100% Jam Proof when used in accordance with the user manual.
SafeSense® Technology Operation
Stops shredding immediately when hands touch the paper opening.
Set-Up and Testing:
- Turn the shredder ON ( ) to activate SafeSense®.
- Touch the test area and look for the SafeSense® indicator (yellow ?) to illuminate.
- SafeSense® is active and working properly.
If the SafeSense® indicator illuminates after paper has been reversed, press Reverse (◀◀) and remove the paper. Otherwise, regular shredding will resume.
Product Maintenance
Oiling Shredder
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.
Follow Oiling Procedure Below and Repeat Twice:
- Apply oil across the paper entry.
- Press and hold Forward (▶) for 2-3 seconds.
CAUTION: Only use a non-aerosol vegetable oil in a long nozzle container, such as Fellowes 35250. ?️
Cleaning Auto-Start Infrared Sensors
Paper detection sensors are designed for maintenance-free operation. However, on rare occasions, the sensors may become blocked by paper dust, causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry).
To Clean the Sensors:
- Turn off and unplug the shredder.
- Locate the auto-start infrared sensor in the center of the paper entry.
- Dip a cotton swab in rubbing alcohol.
- Using the cotton swab, wipe away any contamination from the paper sensors. ?
Troubleshooting
Refer to the indicators on the control panel:
| Indicator | Description |
|---|---|
| A. Overheat Indicator (red ?) | The shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated, and the shredder will not operate during the recovery time. See Basic Shredding Operation for more information on continuous operation and recovery time. |
| B. Bin Open (red ?) | The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding. |
| C. Bin Full (red ?) | The shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053. |
| D. Remove Paper (red ?) | Press Reverse (◀◀) and remove paper. Reduce the paper quantity to an acceptable amount and refeed into the paper entry. |
| E. SafeSense® Indicator (yellow ?) | If hands are too close to the paper entry, the SafeSense® indicator will illuminate, and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off, and the user must press the power button on the control panel to resume shredding. |
100% Jam Proof System*
Eliminates paper jams and powers through tough jobs.
Disabling the Feature:
- To disable the system, press and hold the Auto button (blue ?) and the Reverse (◀◀) key at the same time.
- Once disabled, the blue Auto light is no longer illuminated. (To re-engage, repeat step 1).
- Shredding can continue with the system disabled; however, a paper jam may occur with too many sheets, and the Remove Paper icon (?) will illuminate.
Clearing a Jam (if feature is disabled or misfeed occurs):
- If a jam occurs, press and hold the Forward (▶) key until the document is completely through the shredder.
- If the jam is not cleared, press Reverse (◀◀) briefly (repeat steps 1 and 2 until shredded).
- If steps 1 and 2 do not clear the jam, reverse the paper all the way out, remove several sheets, and refeed.
*100% Jam Proof when used in accordance with the user manual.
Limited Product Warranty
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for the lifetime of the shredder. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller.
ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact Fellowes or your dealer.
Questions or Concerns?
Website: www.fellowes.com
Customer Service & Support: Troubleshooting, Replacement parts, General questions.
Contact Numbers:
- Canada: +1-800-665-4339
- Mexico: +1-800-234-1185
- United States: +1-800-955-0959
Company Address: Fellowes, Inc., 1789 Norwood Avenue, Itasca, Illinois 60143-1095 USA
Part No. 406775
