Patio Bar Table Instruction Manual
Don't fully tighten all the bolts till the very end!
Parts List
| Part | Description | Quantity |
|---|---|---|
| A | Frame (main structure) | 1 |
| B | Frame with wheels | 1 |
| C | Side panel with doors | 1 |
| D | Tabletop shelf | 1 |
| E | Middle shelf | 1 |
| F | Door panel | 1 |
| G | Door panel | 1 |
| H | Bottom shelf | 1 |
| I | Lower frame support | 1 |
| J | Top surface | 1 |
| K | Tray/Compartment unit | 1 |
| L | Upper frame support | 1 |
| M | Bolt (M6*35mm) | 4 |
| N | Bolt (M6*40mm) | 18 |
| O | Washer | 22 |
| P | Plastic gasket | 2 |
| Q | Allen wrench | 1 |
Assembly Instructions
Step 1: Attach part (C) to parts (A) and (B) using 4 bolts (N) and 4 washers (O), with Allen wrench (Q).
Diagram shows part C connecting to the main frame sections A and B. A close-up illustrates the bolt and washer being used.
Step 2: Attach part (D) to parts (A), (B), and (E) using 6 bolts (N) and 6 washers (O), with Allen wrench (Q).
Diagram shows the tabletop shelf (D) being attached to the frame sections (A, B) and the middle shelf (E). A close-up shows the bolt and washer connection.
Note: Do not fully tighten any bolts until assembly is complete. Failure to follow these instructions may cause the bolt holes to be misaligned during assembly.
Step 3: Attach part (L) to parts (A), (B), and (E) using 6 bolts (N) and 6 washers (O), with Allen wrench (Q).
Diagram shows the upper frame support (L) being attached to the frame sections (A, B) and the middle shelf (E). A close-up shows the bolt and washer connection.
Step 4: Insert parts (F) and (G) into the designated holes on part (L). Attach part (D) to parts (F) and (G) using 2 bolts (N), 2 washers (O), and 2 plastic gaskets (P), with Allen wrench (Q). Then, insert part (H).
Diagram shows door panels (F, G) being inserted into the upper frame support (L). The tabletop shelf (D) is then attached to these panels using bolts, washers, and gaskets. Finally, the bottom shelf (H) is placed. Close-ups detail the connections.
Note: Do not fully tighten any bolts until assembly is complete. Failure to follow these instructions may cause the bolt holes to be misaligned during assembly.
Step 5: Attach part (I) to parts (A) and (B) using 4 bolts (M) and 4 washers (O), with Allen wrench (Q).
Diagram shows the lower frame support (I) being attached to the main frame sections (A, B). A close-up shows the bolt and washer connection.
Step 6: Place parts (J) and (K) onto the assembled structure.
Diagram shows the top surface (J) and the tray/compartment unit (K) being placed on top of the assembled bar table.
Note: Verify the alignment and adjust. Now fully tighten all the bolts using wrench.
