Genexis FiberTwist P2000 Series: Compact Point-to-Point (PtP) Network Termination

Key Features

• Compact, fully managed Point-to-Point (PtP) network termination.
• Flexible solution suitable for single and multi-dwelling unit deployments.
• Patented Fiber Twist click interface on FTU or bracket for easy DIY installation by the end-user.
• Flexible management via TR-069, CLI, DHCP/TFTP, and SNMP.
• Optional integrated CATV receiver.
• Up to 4 Gigabit LAN ports for connecting external devices, such as a residential gateway and various Layer-2 services.
• LED dimming.
• Compatible with flush-mounted boxes.

Perfect for Any Deployment Scenario

The Genexis Fiber Twist product family is designed to integrate into various deployment models, including single and multi-dwelling unit scenarios. With products from the Fiber Twist FTU family, the termination point can be moved to any location in the house, facilitating service access and installation. Its compact size (110 x 110 x 46 mm) allows the Fiber Twist to fit perfectly into any environment, whether it's the living room, meter cabinet, or basement.

Product Features and Specifications

General Information

• Dimensions (H x W x D): P2110B/P2410/P2411/P2414: 110x110x46 mm; P2420: 121x110x46 mm
• Weight (without CATV): 176 g
• Weight (with CATV): 225 g
• Operating Temperature: 0 - 40 °C
• Storage Temperature: 0 - 70 °C
• Power Supply: 12 Vdc ± 5%

Power Consumption

• P2110B: typ. 3.0 W
• P2410 - P2411: typ. 3.9 W
• P2424: typ. 4.9 W
• P2420: typ. 6.3 W

WAN Interface

• Tx Wavelength: 1310 nm
• Rx Wavelength: 1490/1550 nm
• Optical Output Budget: -9 ... -3 dBm
• Optical Input Budget: -23 ... -3 dBm

Network Interface

• Type: Single-mode fiber optic (ITU-T G.657) SC/APC connector
• Range: Up to 20 km
• Compliance: 1000BASE-BX20-U, 100BASE-BX20-U
• Auto-Sensing: 1Gbit/s and 100Mbit/s

Layer-2 Functions

• Supports Jumbo Frames (up to 9K)
• Managed Quality of Service (QoS)
• Network Terminator
• Remote port enable/disable
• Remote rate shaping per port
• Up to 64 VLANs or 802.1q transparent
• Q-in-Q (PVID 88a8)

User Interfaces

• 1 x Release button
• 1 x Reset button ***
• 1 x LED dimming button ****
• 1 or 4x LAN interfaces
• 1 x Power connector
• 1 x CATV output coaxial F-connector *
• 1x Telephone FXS/RJ11 connector *

Voice Functions *

• SIP-based Voice-over-IP
• G.711 A-law / µ-law Codec
• G.729 Codec
• 5 REN support
• Line echo cancellation
• DTMF: In-band, RFC2833, SIP-info
• Class 5 features

LAN Interfaces

• Up to 4 x 1000/100/10 Base-T RJ45 interfaces
• LED indicators for link and activity

CATV *

• Wavelength (typical): 1550 nm
• Optical Return Loss min: -8 ... 0 dBm
• RF Passband: 45-900 MHz
• RF Output Impedance: 75 Ω
• F-connector length: 11 mm
• AGC Optical Input Power: -9 ... 0 dBm
• RF Output Level (AGC on) after CNR: 14 dB
• RF Flatness: max 2 dB
• Output Return Loss: max -10 dB
• Tilt: 1 ... 4 dB
• CNR: min 47 dB@-8 dBm (Calculated RF output)
• CSO / CTB: max -57 dBc
• Harmonics to carrier: max -57 dBc

Management

• Network Terminator
• TR-069, TR-181
• G.FAST (7.0 and higher)
• CLI
• DHCP/TFTP
• IEEE 802.3ah OAM in Passive mode: Discovery, Loopback
• Media Converter
• DHCP/TFTP
• IEEE 802.3ah OAM in Passive mode: Discovery, Loopback
• Remote Monitoring
• CATV input signal

Emissions and Safety Regulations

• CE approved, FCC on request
• Safety: IEC EN 60950 or IEC EN 62368-1
• Laser Safety: IEC EN 60825-1: Class 1 laser
• Emissions & Immunity: EN 55032/CISPR 32:2008, Class B; EN 55024
• RoHS/WEEE Marking: Compliant with 2011/65/EU

Status LEDs

• Power
• Fiber optic uplink status/activity
• CATV status *
• Telephony status *

Genexis Fiber Twist P2000-Series Product Models

Note: Not every listed feature may be included in the delivered product. Genexis reserves the right to make changes to technical specifications, housing, or design without prior notice.