RED declaration | FiberTwist
Installation Guide for genexis models including: P2110, FiberTwist Series, FiberTwist
FiberTwist |
File Info : application/pdf, 7 Pages, 1.26MB
DocumentDocumentP2110 FiberTwistSeries Installation Guide Button overview Unlock button Remove FiberTwist or Blind Cover press and hold while twisting counterclockwise LED dim button Dim LEDs press and release to dim LEDs in steps Port overview LAN port Power port LED overview System Green system ok Off power off Uplink Green link ok Off no link Installation guide Different language versions of this document and additional product information are available on https://genexis.eu/product/fibertwist/downloads Box contents · Genexis FiberTwist (active device) · Power adapter · Label (self-adhesive) · Installation Guide (this document) Label position The product label is positioned on the back of the active device. Important: Instructions need to be followed precisely and uninterrupted. This minimizes the risk of damage to the fiber optic connectors, causing a severe degradation of signal quality. Preparation Ensure there is a power socket within reach of where the device is being installed. Remove Blind Cover (if present) 1. Press and hold the unlock button (see button overview). 2. Rotate the Blind Cover counterclockwise till it blocks. 3. Remove the Blind Cover from the baseplate (FTU) by pulling it towards yourself. 4. Store the Blind Cover in a safe place. Remove dust cap 1. Take the FiberTwist out of the box. 2. The dust cap is connected to the red string located on the rear of the FiberTwist. 3. Remove the dust cap by pulling the red string. 4. Store the dust cap in a safe place. Twist! 1. Place the FiberTwist on the FTU as shown in the picture below, in a 30degree angle. 2. Rotate clockwise until it clicks into place. 3. Make sure the FiberTwist is aligned squarely on the FTU, each edge must line up directly with the FTU below. Your FiberTwist is now installed! Connecting the FiberTwist 1. If required, connect your personal devices to the LAN ports via an RJ45 network cable. 2. Connect the supplied power adapter to the FiberTwist and plug the adapter into a power socket. If at some point in the future it becomes necessary to uninstall the FiberTwist, please place the Blind Cover back on the FTU immediately and put the dust cap back on the FiberTwist. Warning: The FiberTwist is a Class 1 laser product. EU Declaration of Conformity Hereby, Genexis B.V. declares that the product FiberTwist-P2110 is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, Delegated Directive 2015/863 and Ecodesign Directive 2009/125/EC. The full text of the EU declaration of conformity is available at the following internet address: https://genexis.eu/red/ft-P2110 Company Name Genexis B.V. Signature of authorized person Company Address Lodewijkstraat 1a 5652 AC Eindhoven The Netherlands Name and title of authorized person Maarten Egmond, CTO Place of issue Eindhoven The Netherlands Date of issue 2020-07-03 Revision 1.3 - June 2021 - Copyright © 2021 Genexis Netherlands B.V. All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.