DEJSA Ceiling Lamp

Important Information & Safety

ℹ️ For indoor use only.

CAUTION: Before starting, turn off power at the main circuit panel.

Importador/Distribuidor: IKEA Supply Mexico, S.A. de C.V., Calle Oriente 158, número 440, Piso 3, Local JD-01, Colonia Moctezuma, Segunda Sección, Alcaldía Venustiano Carranza, C.P. 15530, Ciudad de México. Tel. 55-8310-8310. Read and follow all safety and operation instructions before using this product. For indoor use only. Consult electrical specifications on the product label.

Assembly Overview

This document provides assembly instructions for the DEJSA ceiling lamp.

[Diagram: A person pointing to a screwdriver with a cross mark, indicating a required tool.]You will need a screwdriver for assembly.

[Diagram: Two figures contemplating assembly. One figure looks confused with parts, the other is looking at an IKEA box and seems to have a solution.]If you encounter difficulties, consult the IKEA resources or seek assistance.

[Diagram: A single lamp shade shown with '3x' next to it.]This lamp requires 3 shades.

Step 1: Mount the Ceiling Bracket

1

[Diagram: The main ceiling mounting bracket is shown being lifted upwards towards the ceiling. A close-up view shows two fasteners (screws and nuts) being used to secure a bracket component.]Attach the main ceiling bracket to the mounting surface. Use the provided fasteners (2x). Ensure it is securely fixed.

Step 2: Attach Secondary Component

2

[Diagram: A secondary bracket or component is shown being attached to the main bracket with a screw, indicated by an upward arrow.]Attach the secondary component to the main bracket using a screw.

Step 3: Route Wires

3

[Diagram: The wires are being fed through openings in the mounted bracket assembly.]Carefully route the electrical wires through the designated openings in the bracket.

Step 4: Connect Wires

4

[Diagram: A close-up shows three sets of wires being connected using wire connectors. The connectors are shown being twisted onto the wires. '3x' indicates the number of connectors.]Connect the wires using the provided connectors (3x). Follow the color coding:

Live (Phase / Con corriente)Neutral (Neutre / Neutro)Earth/Ground (Terre / Tierra)

[Diagram: Shows three wires: one black (Live), one white/blue (Neutral), and one green/yellow (Earth/Ground), each being connected with a wire nut.]

Step 5: Attach Lamp Body

5

[Diagram: The main lamp body assembly is shown being attached to the ceiling bracket, with a screw indicated by an upward arrow.]Secure the main lamp body to the ceiling bracket.

Step 6: Route Wires into Fixture

6

[Diagram: The electrical wires are being guided into the main lamp fixture body.]Guide the connected wires into the lamp fixture.

Step 7: Install Light Bulbs

7

[Diagram: Light bulbs are shown being screwed into the lamp sockets. Circular arrows indicate the twisting motion.]Screw the light bulbs into the sockets. Ensure they are firmly seated.

Step 8: Attach Lamp Shades

8

[Diagram: A lamp shade is shown being attached to one of the lamp arms. Circular arrows indicate a twisting or securing motion. A final image shows the lamp with shades being attached.]Attach the lamp shades to the fixture. Follow the indicated method for securing each shade.

[Diagram: A hand is shown pressing a clip or tab to secure a component, likely a shade or part of the shade assembly.]Ensure all shades are securely attached.

Completion

Your DEJSA ceiling lamp is now assembled and ready for use.

© Inter IKEA Systems B.V. 2022