DEJSA Ceiling Lamp
Brand: IKEA
Important Safety Information
For indoor use only.
IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice. Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material.
Tools and Components
Required tools:
- Screwdriver ?
- Scissors ✂️
- Tape measure ?
Components:
- Main lamp body
- Three glass lamp shades
- Mounting bracket
- Screws (for mounting bracket)
- Electrical wires
- Terminal block
- Suspension rods
Assembly Steps
Step 1: Prepare for Installation
Ensure you have all necessary tools and components. The lamp requires three light bulbs (not included).
Step 2: Mount the Ceiling Bracket
Attach the metal mounting bracket to the ceiling using two screws. Ensure the bracket is securely fastened.
Step 3: Feed Wires and Attach Lamp Body
Feed the electrical supply wires through the designated opening in the ceiling or mounting bracket. Then, attach the main lamp body to the mounting bracket.
Step 4: Prepare and Connect Wires
Strip approximately 20 mm (13/16 inches) of insulation from the ends of the electrical wires. Connect the live (L) and neutral (N) wires to the corresponding terminals in the connection block. Ensure secure connections.
Step 5: Install Suspension Rods
Insert the three suspension rods into their respective sockets on the lamp body. Secure them in place.
Step 6: Final Wiring and Securing
Connect the wires from the suspension rods to the main terminal block, ensuring correct polarity (L to L, N to N). Close and secure any protective covers for the wiring compartment.
Step 7: Install Light Bulbs and Shades
Screw in the three light bulbs (not included). Carefully attach the three glass lamp shades to the lamp sockets by twisting them into place until secure.
Step 8: Final Check
Ensure all parts are securely attached and all electrical connections are correct before powering on the light.
