TÄLLBYN Pendant Lamp with 3 Lamps

Safety and Compliance Information

CAUTION: Before starting, turn off power at the main circuit panel.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

SAVE THESE INSTRUCTIONS

Assembly Instructions

Step 1: Attach the main fixture body to the ceiling mount. Hands are shown securing the three lamp cords into the fixture using threaded fasteners, indicated by '3x'.

Step 2: Electrical Wiring. Three types of wires are identified: Live/Phase (English: Live, French: Phase, Spanish: Con corriente), Neutral (English: Neutral, French: Neutre, Spanish: Neutro), and Earth/Ground (English: Earth/Ground, French: Terre, Spanish: Tierra). The diagram illustrates connecting these wires using terminal blocks or connectors, with close-up views showing the correct insertion and securing of wires.

Step 3: Secure the main fixture body to the ceiling mount using screws.

Step 4: Feed the three lamp cords through the main fixture body and secure them using clips, indicated by '3x'.

Step 5: Secure the lamp cords within the fixture body using clips. A close-up shows a clip engaging with a 'click!' sound, indicating proper fastening. '2x' indicates two clips are used per cord.

Step 5 (continued): Securing the lamp cords.

Step 5 (continued): Securing the lamp cords.

Step 6: Insert the lamp holder into the lamp shade.

Step 7: Twist the lamp holder to secure it within the lamp shade.

Step 8: Attach the lamp shade assembly to the lamp holder, tightening a screw mechanism.

Step 9: Final attachment of the lamp shade. A caution is displayed: 'CAUTION! Do not overtighten.' (also in French and Spanish). Illustrations show correct and incorrect tightening methods.

Step 10: Insert the light bulb into the lamp holder.

Step 11: Screw the light bulb into the lamp holder.

Product dimensions are shown: 250 cm (100 inches) and 55 cm (22 inches).