Qhib Ncej Dual Set Point Temperature Controller
Phau ntawv qhia

Phau ntawv luv luv no feem ntau yog txhais tau rau kev siv ceev ceev rau kev sib txuas ntawm kev sib txuas thiab kev tshawb nrhiav parameter. Yog xav paub ntxiv txog kev ua haujlwm thiab kev thov; thov nkag mus rau www.ppiindia.net
NYIAJ NTAU / OTPUT CONFIGURATION PARAMETERS

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Hom tswv yim	Refer Table 1 (Default: Hom K)
Tswj Logic	Reverse Direct (Default: Rov Qab)
Setpoint Tsawg	Min. Ntau yam rau Setpoint Siab rau hom kev xaiv nkag (Default : Min. Range for the ) Xaiv Cov Lus Qhia
Setpoint Siab	Setpoint Tsawg rau ax. Range M rau hom kev xaiv nkag (Default: Max. Range rau cov lus xaiv xaiv ) Xaiv hom tswv yim
Offset rau PV	-1999 txog 9999 lossis -199.9 txog 999.9 (Default : 0)
Digital Lim Rau PV	0.5 txog 25.0 Seconds (hauv cov kauj ruam ntawm 0.5 Seconds) (Default: 1.0)
Tswj cov zis hom	Relay (Default) SSR
Output-2 Muaj nuj nqi xaiv	(Default) Tsis muaj tswb Control Blower Soak Start Output
Output 2 Hom	Relay (Default) SSR

TSEEM CEEB PARAMETERS 

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Tswj hom	(Default) On-Off PID
On-Off Hysteresis	1 txog 999 lossis 0.1 txog 99.9 (Default: 2 lossis 0.2)
Compressor Lub Sijhawm qeeb	0 rau 600 sec. (hauv cov kauj ruam ntawm 0.5 Sec.) (Default: 0)
Lub Sijhawm Sijhawm	0.5 mus rau 120.0 Seconds (hauv cov kauj ruam ntawm 0.5 Seconds) (Default : 20.0 Sec)

Kwv Txhiaj Sawv Daws	0.1 txog 999.9 (Default: 10.0)
Integral Sijhawm	0 mus rau 1000 Seconds (Default: 100 Sec)
Lub Sijhawm Derivative	0 mus rau 250 Seconds (Default: 25 Sec)

OUTPUT-2 FUNCTION PARAMETERS

OP2 Function: Tswb 

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Tswb Hom	Txheej Txheem Tsawg Cov Txheej Txheem Siab Deviation Band Qhov rai Band Xaus Soak (Default: Txheej Txheem Tsawg)
Tswb Inhibit	Yog Tsis Yog (Default: Yog)
Tswb Logic	Normal Reverse (Default: Ib txwm)
Tsa Timer	5 txog 250 (Default: 10)

OP2 muaj nuj nqi: Tswj

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Hysteresis	1 txog 999 lossis 0.1 txog 99.9 (Default: 2 lossis 0.2)
Tswj Logic	Normal Reverse (Default: Ib txwm)

OP2 muaj nuj nqi: Blower 

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Blower / Compressor Hysteresis	1 txog 250 lossis 0.1 txog 25.0 (Default: 2 lossis 0.2)
Blower / Compressor ncua sij hawm	0 rau 600 sec. (hauv cov kauj ruam ntawm 0.5 Sec.) (Default: 0)

SUPERVISORY PARAMETERS

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Self-tune Command	Yog Tsis Yog (Default: Tsis yog)
Overshoot Inhibit Enable / Disable	Disable Enable (Default: Disable)
Overshoot Inhibit Factor	(Default: 1.2) 1.0 txog 2.0
Setpoint Editing Permission on Operator Page	Disable Enable (Default: Enable)
Soak Abort Command ntawm tus neeg teb xov tooj nplooj	Disable Enable (Default: Enable)
Soak Sijhawm hloov kho ntawm tus neeg teb xov tooj nplooj	Disable Enable (Default: Enable)

PERATOR PARAMETERS

OP2 Function: Tswb

Parameters x	Kev teeb tsa (Tus nqi Default)
Soak Start Command	Tsis Yog (Default: Tsis yog)
Soak Abort Command	Tsis Yog (Default: Tsis yog)
Soak Sijhawm	00.05 txog 60.00 M:S lossis 00.05 txog 99.55 H:M lossis 1 txog 999 Teev (Default: 3 lossis 0.3)
Tswb Setpoint	Yam tsawg kawg nkaus rau qhov siab tshaj plaws tau teev tseg rau hom kev xaiv nkag (Default : 0)

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Tswb Deviation	-1999 txog 9999 lossis -199.9 txog 999.9 (Default: 3 lossis 0.3)
Tswb Band	3 txog 999 lossis 0.3 txog 99.9 (Default: 3 lossis 0.3)

OP2 muaj nuj nqi: Tswj 

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Auxiliary Control Setpoint	(Min. Range – SP) rau (Max. Range – SP) (Default : 0)

OP2 muaj nuj nqi: Blower 

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Blower Control Setpoint	0.0 txog 25.0 (Default: 0)

Tswj Setpoint (SP) Xauv

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Setpoint Xauv	Yog Tsis Yog (Default: Tsis yog)

SOAK TIMER PARAMETERS 

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Soak Timer Qhib	Tsis Yog (Default: Tsis yog)
Lub Sijhawm Units	Manse Teev: Min Teev (Default: Min: Sec)
Soak Sijhawm	00.05 txog 60:00 Manse 00.05 txog 99:55 Hrs: Min 1 txog 999 Teev (Default: 00.10 Manse)
Soak pib Band	0 txog 9999 lossis 0.0 txog 999.9 (Default: 5 lossis 0.5)
Holdback Strategy	None Up Down Ob (Default: Tsis muaj)

Tsis muaj	Kev teeb tsa (Tus nqi Default)
Tuav Band	1 txog 9999 lossis 0.1 txog 999.9 (Default: 5 lossis 0.5)
Switch-off Control Output Thaum Timer Kawg	Tsis Yog (Default: Tsis yog)
Fais fab-fail Recovery Method	Txuas ntxiv (Re)Start Abort (Default : Mus Ntxiv)

Kev xaiv	Nws txhais li cas	Ntau yam (Min. to Max.)	Kev daws teeb meem
	Hom J Thermocouple	0 txog + 960 ° C	1
	Hom K Thermocouple	-200 rau + 1375 ° C	1
	3-hlau, RTD Pt100	-199 rau + 600 ° C	1
	3-hlau, RTD Pt100 -	-199.9 rau + 600.0 ° C	0.1

PANEL PANEL LAYOUT

Cov Board Saib Xyuas
Small Display Version
0.39 "siab, 4 Tus lej, Sab Saum
0.39 "siab, 4 Tus lej, Kab qisLoj Display Version
0.80 "siab, 4 Tus lej, Sab Saum
0.56 "siab, 4 Tus lej, Kab qisTswj BoardLayoutCov yuam sij ua haujlwm

Cim	Ntsiab	Muaj nuj nqi
	PAGE	Nias kom nkag los yog tawm ntawm kev teeb tsa hom.
	POM	Nias kom txo tus nqi parameter Nias ib zaug txo tus nqi los ntawm ib qho suav; tuav pressed speeds li hloov.
	UP	Nias kom nce tus nqi parameter Nias ib zaug nce tus nqi los ntawm ib qho suav; tuav pressed speeds li hloov.
	ENTER	Nias kom khaws cov nqi parameter thiab mus scroll mus rau qhov parameter tom ntej ntawm PAGE.

PV yuam kev Indications

Xov xwm	PV yuam kev hom
	Ntau tshaj (PV saum toj no Max. Range)
	Under-range (PV hauv qab Min. Range)
	Qhib (Thermocouple / RTD tawg)

Kev sib txuas hluav taws xob

101, Pob zeb diamond Industrial Estate, Namghar,
Vasai Road (E), Dist. Palghar – 401 210.
Muag: 8208199048 / 8208141446
Xov tooj: 07498799226 / 08767395333
E: sales@ppiindia.net,
support@ppiindia.net

Cov ntaub ntawv / Cov ntaub ntawv

PPI OmniX BTC Qhib Ncej Dual Set Point Temperature Controller [ua pdf] Phau ntawv qhia OmniX BTC, OmniX BTC Qhib Ncej Dual Set Point Temperature Controller, Qhib Ncej Dual Set Point Temperature Controller, Dual Set Point Temperature Controller, Temperature Controller

Cov ntaub ntawv

• Cov neeg siv phau ntawv