INSTRUCCIÓN DE USO
Programador de enderezos de terminal
| PRG.PAS.MCS |
| 170 x 112 x 35 mm/ 270 g |
| Plastic case + mechanical keyboard 0°C … 45°C – IP 31 |
| Fonte de alimentación: 9 V (batería/batería recargable) |
| Conexión ao terminal mediante cable de conexión UTP de 0.25 cm |
| Enderezos dispoñibles para programación: entre “000” e “998” Ao escribir “999”, remata a programación de enderezos. |
DESCRICIÓN
O PRG.PAS.MCS programmer allows the programming of the address (apartment number) for all types of terminals in the Liña Clásica range: PAS.17A, PAS.27X, PAS.37X, MCS.47X.
This programmer serves as the mobile alternative to the terminal address programming function, enabling the address to be programmed both on-site and in the office, by a single person.
CONEXIÓN AO TERMINAL
- Cable de conexión UTP de 0.25 cm
- De volta
- Fronte
- Programador PRG.PAS.MCS
- Terminal de vídeo: audio (MCS.47X, PAS.27X, PAS.37X)
ON/OFF
- The programmer is turned on by pressing the ON key.
- The programmer turns off:
– 3 seconds after entering the last digit of the programmed address;
– 10 seconds after being turned on, if no key is pressed.
PROGRAMACIÓN
Paso 1: Connect the programmer to the terminal.
Paso 2: Preme o ON key on the programmer → The display shows [Enderezo da publicación].
Paso 3: On the terminal, press and hold the 
chave.
Paso 4: On the programmer, enter the terminal address to be programmed (3 digits required). After entering the last digit, the terminal will issue a confirmation beep, and the key can be released.
07.2025 INS.PRG.PAS.MCS
MADE in EU por:
ELECTRA srl
Parque Industrial Miroslava
Str. Principala 33, 707307, Jud. Iași - RO
+40 232 214.370
sales@electra.ro
www.electra.ro
APOIO
ELECTRA Building Communications GmbH
Gadnergasse 71, Stockwerk 1, Büro Top 132
1110 Wien – AT
+43 1 810 20 99
sales@electra-automation.at
www.electra-automation.at
Documentos/Recursos
 |
Programador de enderezos de terminal Electra PAS.17A [pdfManual de instrucións PAS.17A, PAS.27X, PAS.37X, MCS.47X, PAS.17A Programador de enderezos de terminal, PAS.17A, Programador de enderezos de terminal, Programador de enderezos, Programador |