classic Line logo Electra logo

KASUTUSJUHEND

Terminali aadressi programmeerija

Electra PAS.17A Terminal Address Programmer 0

PRG.PAS.MCS
170 x 112 x 35 mm/ 270 g
Plastic case + mechanical keyboard 0°C … 45°C – IP 31
Power supply: 9V (battery/rechargeable battery)
Connection to the terminal via UTP Patch Cable 0.25 cm
Addresses available for programming: between “000” and “998”
Typing “999” ends the address programming.
KIRJELDUS

The PRG.PAS.MCS programmer allows the programming of  the address (apartment number) for all types of terminals in the Klassikaline liin range: PAS.17A, PAS.27X, PAS.37X, MCS.47X.
This programmer serves as the mobile alternative to the terminal address programming function, enabling the address to be programmed both on-site and in the office, by a single person.

CONNECTION TO THE TERMINAL

Electra PAS.17A Terminal Address Programmer 1

  1. UTP Patch Cable 0.25 cm
  2. Tagasi
  3. Esiosa
  4. PRG.PAS.MCS Programmer
  5. Terminal video – audio (MCS.47X, PAS.27X, PAS.37X)
SISSE/VÄLJA
  1. The programmer is turned on by pressing the ON key.
  2. The programmer turns off:
    – 3 seconds after entering the last digit of the programmed address;
    – 10 seconds after being turned on, if no key is pressed.
PROGRAMMEERIMINE

1. samm: Connect the programmer to the terminal.
2. samm: Vajutage nuppu ON key on the programmer → The display shows [Adresa post].
3. samm: On the terminal, press and hold the Key plus võti.
4. samm: On the programmer, enter the terminal address to be programmed (3 digits required). After entering the last digit, the terminal will issue a confirmation beep, and the Key plus key can be released.

07.2025 INS.PRG.PAS.MCS


TOODETUD EL-is:
ELECTRA srl
Miroslava tööstuspark
Str. Principala 33, 707307, Jud. Iași – RO

Telephone-A1 Fax-A1 +40 232 214.370
Message-A1 sales@electra.ro
Globel AA1 www.electra.ro

TUGI
ELECTRA Building Communications GmbH
Gadnergasse 71, Stockwerk 1, Büro Top 132
1110 Wien – AT

Telephone-A1 Fax-A1 +43 1 810 20 99
Message-A1 sales@electra-automation.at
Globel AA1 www.electra-automation.at

Dokumendid / Ressursid

Electra PAS.17A Terminal Address Programmer [pdfKasutusjuhend
PAS.17A, PAS.27X, PAS.37X, MCS.47X, PAS.17A Terminal Address Programmer, PAS.17A, Terminal Address Programmer, Address Programmer, Programmer

Viited

Jäta kommentaar

Teie e-posti aadressi ei avaldata. Kohustuslikud väljad on märgitud *