POUŽÍVEJTE NÁVOD
Programátor adres terminálů
PRG.PAS.MCS |
170 x 112 x 35 mm/ 270 g |
Plastic case + mechanical keyboard 0°C … 45°C – IP 31 |
Napájení: 9V (baterie/dobíjecí baterie) |
Připojení k terminálu pomocí UTP patch kabelu 0.25 cm |
Adresy dostupné pro programování: mezi „000“ a „998“ Zadáním „999“ ukončíte programování adresy. |
POPIS
The PRG.PAS.MCS programmer allows the programming of the address (apartment number) for all types of terminals in the Klasická linie range: PAS.17A, PAS.27X, PAS.37X, MCS.47X.
This programmer serves as the mobile alternative to the terminal address programming function, enabling the address to be programmed both on-site and in the office, by a single person.
PŘIPOJENÍ K TERMINÁLU
- UTP patch kabel 0.25 cm
- Zadní
- Přední
- Programátor PRG.PAS.MCS
- Terminál video – audio (MCS.47X, PAS.27X, PAS.37X)
ON/OFF
- The programmer is turned on by pressing the ON key.
- The programmer turns off:
– 3 seconds after entering the last digit of the programmed address;
– 10 seconds after being turned on, if no key is pressed.
PROGRAMOVÁNÍ
Krok 1: Connect the programmer to the terminal.
Krok 2: Stiskněte tlačítko ON key on the programmer → The display shows [Adresa příspěvku].
Krok 3: On the terminal, press and hold the klíč.
Krok 4: On the programmer, enter the terminal address to be programmed (3 digits required). After entering the last digit, the terminal will issue a confirmation beep, and the key can be released.
07.2025 INS.PRG.PAS.MCS
VYROBENO v EU:
ELECTRA srl
Parc Industrial Miroslava
Str. Principala 33, 707307, Jud. Iaşi – RO
+40 232 214.370
sales@elektra.ro
www.elektra.ro
PODPORA
ELECTRA Building Communications GmbH
Gadnergasse 71, Stockwerk 1, Büro Top 132
1110 Wien – AT
+43 1 810 20 99
sales@elektra-automation.at
www.electra-automation.at
Dokumenty / zdroje
![]() |
Programátor adres terminálů Electra PAS.17A [pdfNávod k obsluze PAS.17A, PAS.27X, PAS.37X, MCS.47X, PAS.17A Programátor terminálových adres, PAS.17A, Programátor terminálových adres, Programátor adres, Programátor |