ESP8266 8 Relay WiFi Module
Instruction Manual
Hardware introduction and description
1, Board size: 150100mm
Weight: 284g
Interface Introduction
Programming port: GND, RX, TX, 5V of ESP8266 are respectively connected to GND of external TTL serial port module, TX, RX, 5V, 00 needs to be connected to GND when downloading, disconnect the connection between I00 and GND after downloading;
relay output
NC: Normally closed terminal, the relay is short-circuited with COM before it is pulled in, and it is left in the air after it is pulied in;
COM: public terminal;
No: Normally open, the relay is suspended before closing, and short-circuited with COM after closing.
GPIO lead port introduction
Adn development environment setup
ESP32 supports Eclipse/ Adn IDE and other development tools. it is relatively simple touseAdn __. The following is howto build anAdn development environment
- InstallAdn ide1.89 or the latest version
- Open the ide, click File-Preferences in the menu bar, and after entering the preferences, click Add URL
http://arduino.esp8266.com/stable/packageesp8266comindex.json in “Additional Development Board Manager URLs”
- Click Tools-Development Soard-Development Board Manager in the menu bar, and then search for “ESP8266” to install Ad n support package for ESP8266 2.5.2 or the latest version.
Note: Since the download URL is from abroad, the access speed is relatively slow, and there may be download errors. Just try a few more times when the network is good. - Program download
- Use a jumper cap to connect the }00 and GND pins, prepare a TTL serial port module (for example: FT232) and plug it into the computer USB, the connection method between the serial port module and the development board is as follows TTL serial port module
TTL serial port module ESP8266 development board GND GND TX RX RX TX 5V 5V - Click Tools – Development Board in the menu bar and select the development board as Espino (ESP-12 module)
- Open the program to be downloaded, click Tools-Port in the menu bar to select the correct port number
- After clicking “Upload”, the program will be automatically compiled and downloaded to the development board, as follows:
- Use a jumper cap to connect the }00 and GND pins, prepare a TTL serial port module (for example: FT232) and plug it into the computer USB, the connection method between the serial port module and the development board is as follows TTL serial port module
- Finally disconnect the connection between 00 and GND, power on the development board again or press the reset button to run the program.
Documents / Resources
 |
TARJ ESP8266 8 Relay WiFi Module [pdf] Instruction Manual ESP8266 8 Relay WiFi Module, ESP8266, 8 Relay WiFi Module, WiFi Module, Module |
