MIKRO Flash the Reference Design via Bootloader

How to flash the Reference Design via Bootloader

Step 1

Install Renesas Flash Programmer V3.09 or later: https://www.renesas.com/us/en/software-tool/renesas-flash-programmer-programming-gui#download

Step 2

Put Jumper on Pin 7 and Pin 9 of the Debug Interface.

Step 3

Connect the Device to the PC.

Step 4

Open Renesas Flash Programmer:

1. Open new Project: File >> New Project
2. Fill out the tabs:
   • Microcontroller: RA
   • Project Name: create your project name
   • Project Folder: your project folder path
   • Communication Tool: COM Port >> Tool Details: your COM Port number
3. Connect
4. Browse and select the wanted .srec file and Click “Start”
   The .srec file is available at https://github.com/Broadcom/AFBR-S50-API/releases
5. If flashing was successful, “operation completed” is displaying at the console. (as illustrated in the picture)

Step 5

Jumper needs to be removed or set to its initial position again (not flashing position) otherwise the board will not be functional in normal operation.

Documents / Resources

MIKRO Flash the Reference Design via Bootloader [pdf] Instructions Flash the Reference Design via Bootloader, Flash the Reference Design, Bootloader Flash the Reference Design, Flash the Reference Design Using Bootloader, Bootloader

References

• User Manual