INSTRUCTIONS

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.

SURFACE MOUNT KIT MOUNTING

Visual Description: The main illustration shows the components of the surface mount kit, including a U-shaped bracket, a finned heat sink, screws, and pivot bolts, with labels pointing to specific parts.

1. Align the Surface Mount Kit screw holes with the Heat Sink as shown in Fig. 1, and 2.
2. Diagram Description: Figure 1 shows the alignment of the Surface Mount Kit screw holes with the Heat Sink. Figure 2 shows the Surface Mount Kit installed onto the Heat Sink, indicating screw holes.
3. Install the Surface Mount Kit onto the Heat Sink.
4. Secure the Surface Mount Kit to the Heat Sink with (4) 5x12mm Screws (provided) as shown in Fig. 3.
5. Diagram Description: Figure 3 shows a close-up of four 5x12mm screws being used to fasten the Surface Mount Kit to the Heat Sink.
6. To adjust the fixture angle, loosen Pivot Bolts and set fixture to desired angle as shown in Fig. 4.
7. Diagram Description: Figure 4 shows a close-up of the Pivot Bolts, indicating their location for adjusting the fixture's angle.
8. Tighten Pivot Bolts to set angle.

CLEANING & MAINTENANCE

CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is energized.

1. Clean fixture and components with non-abrasive cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the LED.