SATVPRO Series Bathtub Installation Guide

Preparation and Tools

Before beginning the installation, gather the necessary tools and materials:

• [Measuring tape]
• [Pencil]
• [Spirit level]
• [Measuring tape with scale]
• Sanitary Silicone

[Information] icon indicates important notes during the installation process.

Product Dimensions

The following table outlines the dimensions for the different SATVPRO bathtub models:

Installation Steps

Step 1: Base Placement

Place the bathtub on a prepared, stable, and level base. Ensure the foundation can support the weight of the bathtub and water.

Step 2: Attach Supports

Attach the adjustable feet or support brackets to the underside of the bathtub. These components are crucial for leveling the unit.

Step 3: Position Bathtub

Carefully position the bathtub onto the installed supports. Align it approximately with the final desired location in the bathroom.

Step 4: Secure Supports

Secure the bathtub to the supports using the provided brackets and screws. Adjust the feet to achieve the correct height and initial leveling.

Step 5: Leveling and Adjustment

Fine-tune the height and level of the bathtub using the adjustable feet. Use a spirit level to ensure the bathtub is perfectly horizontal and stable in all directions.

Step 6: Wall Mounting

Fix the bathtub securely to the wall using appropriate mounting hardware. This step adds essential stability and prevents movement.

Step 7: Tiling and Sealing Preparation

The diagram illustrates tiling around the bathtub. It is critical to ensure a proper seal between the bathtub edges and the wall or tiles. A warning symbol [Incorrect sealing/tiling] is shown, indicating the importance of correct application.

Step 8: Water Test

Fill the bathtub with water. Leave the water in the tub for a minimum of 24 hours. This allows for final stability checks and verifies the integrity of the seals and connections. [Fill with water and wait 24 hours] is indicated by a water tap symbol and timer.

Step 9: Final Sealing

Apply sanitary silicone sealant around all edges where the bathtub meets the wall or tiles. This creates a watertight barrier, preventing water damage.

Manufacturer Information

SAT® is a registered trademark of Swiss Aqua Technologies AG.

Address: Gewerbestrasse 9, 6330 Cham, Switzerland

Website: www.swatec.ch