Shada Solar LED Floodlight

Product Overview

This document provides essential safety, installation, maintenance, and disposal information for the Shada Solar LED Floodlight, model number 0300417.

Safety Instructions

Ensure you have read and understood the instructions in this document fully before installing or using the product in accordance with the installation/wiring diagram (if applicable). Save this document for future reference and use the product only as described in this document. Any use of the product other than as described in this manual may damage the product or injure the user (e.g., short circuit, fire, or electric shock). Disconnect the product from the power source if problems occur. Do not drop the product and avoid impacts. Do not use the product if any part is damaged or defective. Immediately replace a damaged or defective product. If work must be performed on high-voltage lines, it must be carried out by a qualified electrician to reduce the risk of electric shock. Ensure adequate ventilation of the product during use. Never cover an electrical (LED) unit during use, as this generates heat and can cause damage. LEDs can be extremely bright and cause serious eye damage, never look directly into the light source! If a product is intended for indoor and/or outdoor use only, this is indicated on the product/components or in the manual. Keep the product out of reach of children and animals.

The product is rated IP54, meaning it is dust-proof and splash-proof. It is also a Class III device, designed to be powered from a separated extra-low voltage (SELV) source.

Note: Opening the device in any other way than described will void the warranty [warranty void symbol].

Warranty and After-Sales Service

Our Shada products are subject to strict quality standards and are regularly checked for their technical properties and functions by independent test institutes. We provide a 24-month warranty on this product, provided it has been used, installed, and maintained as intended. Full warranty conditions for our Shada products and further information can be found on our website. If you need further assistance or have comments or suggestions, please visit www.shada.nl/nl/contact or contact Shada directly.

Cleaning and Maintenance Instructions

Do not use cleaning agents or abrasives. Do not clean the inside of the unit. Repairs to the product should only be carried out by qualified professional personnel. Clean the outside of the unit with a soft, damp cloth (do not use a microfiber cloth).

Disposal Instructions

In accordance with the European WEEE directive, electrical and electronic appliances must not be disposed of with household waste. Their components must be recycled or disposed of separately as they can be toxic and hazardous. Incorrect disposal of components can cause permanent damage to the environment. Details are regulated by the respective national legislation. The symbol on the product, the user manual and/or packaging refers to these regulations [WEEE recycling symbol]. By separating, recycling and disposing of old appliances, you make an important contribution to protecting our environment.

Replaceable batteries and lamps must be removed from the electrical/electronic product before returning the product/products for recycling and must be offered separately.

Disposal of Lighting Fixtures:

• With replaceable light source: Remove the light source from the lamp and hand in the light source separately for recycling (collection point for electronic waste). If both the light source and the surrounding product (e.g., lampshade) are to be disposed of, the light source and the surrounding product must be offered separately. Check if the lamp can be repaired (e.g., by replacing the light source) to avoid unnecessary electronic waste.
• With permanently installed light source: The light source cannot be replaced. Please recycle the entire product.
• With separate/replaceable power supply: Check if the lamp can be repaired (e.g., by replacing the power supply) to avoid unnecessary electronic waste. If it is not possible to replace the power supply, recycle the product.
• With integrated/non-replaceable power supply: The power supply cannot be replaced. Please recycle the entire product.

For the environment! In terms of sustainability, large amounts of electronic waste can be avoided by replacing light sources and other components (e.g., power supplies). Therefore, check if replacement light sources or other replaceable components are available. These can usually be provided quickly and free of charge during the warranty period.

The product carries the CE mark [CE marked], confirming compliance with EU safety, health, and environmental protection requirements.

Diagram Descriptions

Dimensions

Diagram showing the dimensions of the solar LED floodlight. The main body has a length of approximately 136.0 mm. The width is approximately 52.0 mm, with mounting points extending 20.0 mm on each side. The height is approximately 26.0 mm.

Installation

Installation diagram. Step 1: Mark mounting points on the wall using the bracket as a template. Step 2: Drill holes (8mm diameter) and insert wall plugs. Step 3: Attach the mounting bracket to the wall. Step 4: Slide the floodlight onto the bracket. The diagram indicates a minimum distance of 40mm from the surface to the bracket.

Features and Operating Modes

Diagram illustrating the floodlight's features and modes. It shows a sensor with a 120° detection angle and a maximum range of 6 meters at an installation height of 2 meters. The light sensitivity (LUX) can be set to 50 lux. The operating modes are:

• Mode 1X: Light stays on for 18 seconds at 100% brightness.
• Mode 2X: Light stays on for 18 seconds at 40 lumens.
• Mode 3X: Light operates at 40 lumens with SENSOR OFF (continuous light).
• Mode 4X: Light is OFF (standby).

Solar Panel, Battery, and Disposal Symbols

Diagram showing the solar panel [sun] on top of the unit, a Li-Ion battery symbol [battery], and the WEEE symbol [WEEE recycling symbol] indicating separate collection for electrical and electronic waste. It also shows recycling symbols [recycling symbol] for paper/cardboard and plastic packaging.