SHADA LED Light Installation and Safety Guide

Installation

This guide details the installation process for your SHADA LED light. Please ensure you have read and understood all instructions before beginning.

Mounting

The fixture is designed for wall mounting. Securely attach the unit to a suitable surface. Diagrams show the fixture being positioned and fixed to a wall, with a note indicating a minimum clearance of 15cm from other surfaces.

Wiring

Important: Electrical connections should be made by a qualified person. If you are unsure, consult a professional electrician.

Connect the power supply cables to the corresponding terminals inside the fixture: Live (L), Neutral (N), and Earth. Ensure all connections are made securely within the provided cable glands and connectors. The diagrams illustrate the process of stripping wires and connecting them to the internal terminals.

Final Steps

After wiring, secure all connections and test the fixture. The fixture should illuminate when power is supplied. A warning symbol ⚠️ with an electrical hazard symbol ⚡ highlights the risk of electric shock.

LED Module Replacement

Note: Opening the device will void the warranty. This procedure must be performed by qualified personnel only.

If the LED module needs replacement, follow these steps: Open the fixture, disconnect the old module, clean the new module with 70% alcohol, connect the new module's wires to the fixture's terminals, and reassemble the unit. Diagrams illustrate the sequence of opening, disconnecting, cleaning, connecting, and closing the fixture.

Safety Information

⚠️ WARNING: Risk of Electric Shock!

• Always disconnect the power supply before installation, maintenance, or module replacement.
• Do not stare directly at the LED light source, as it is very bright and can cause serious eye damage.
• Ensure the product is installed in a well-ventilated area. Do not cover the device during operation, as it may generate heat and cause damage.
• Keep the product out of reach of children and animals.
• Avoid dropping the product or subjecting it to impacts.
• Use the product only as described in this manual.
• If any part is damaged or defective, replace the entire product immediately.
• For non-standard electrical installations, always use a qualified technician to minimize the risk of electric shock.

Cleaning and Maintenance

• Clean the exterior of the device using only a soft, damp cloth.
• Do not use cleaning solvents or abrasive materials.
• Never clean the inside of the device.
• Do not attempt to repair the device if it malfunctions; replace it instead.

Disposal and Compliance

CE Marking: This product complies with EU safety, health, and environmental protection requirements.

WEEE Disposal: This item must be disposed of separately from household waste. Please return it to a designated recycling facility in accordance with local environmental regulations. This action helps reduce waste volume and minimize potential negative impacts on human health and the environment.

Support: For additional assistance, comments, or suggestions, please visit: https://www.shada.nl/nl/contact

Declaration of Conformity (D.O.C.): shada.nl/p/310702