Ingenuity Boutique Collection Rocking Seat - Bella Teddy

Safety Warnings

FALL HAZARD:

Children have suffered head injuries falling from rockers.

• NEVER leave the child unattended.
• ALWAYS use the restraint system. Adjust to fit snugly.
• Stop using restraint system once the child tries to stand up and is able to climb in and out of the rocker.
• DO NOT move or lift this product with the baby inside it. Never lift product using a toy bar as a handle.
• NEVER place a child over 40 lb (18 kg) in the product.
• The reclined position is only for children who cannot sit upright unassisted (until 20 lb or 9 kg). Stop using reclined position when baby starts trying to sit up.
• The upright position is only for children who have developed enough upper body control to sit up without tipping forward.
• NEVER use this product on an elevated surface (e.g. a table). ALWAYS use on the floor.
• DO NOT place this product near a window as it can be used as a step by the child and cause the child to fall out of the window.
• Be aware of the risk of open fires and other sources of strong heat in the vicinity of the product.
• DO NOT place this product near a window where cords from blinds or curtains could strangle a child.

SUFFOCATION HAZARD:

Babies have suffocated when seats tipped over on soft surfaces.

• NEVER use on a bed, sofa, cushion, or other soft surface.
• Stay near and watch baby during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby as soon as possible and place baby on a firm, flat sleep surface such as a crib or bassinet.
• Never let the child sleep in this product.
• NEVER attach any additional strings or straps to product or toy bar.
• NEVER use as an infant carrier or for automobile or airline travel.

Important Information

Adult assembly required.

• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts.
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
• This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.

Care and Cleaning

• Seat pad/Bolster/Headrest: Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat. ??
• Toy bar and toys: Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame: Wipe the metal frame with soft, clean cloth and mild soap.

Battery Information

The Music/vibration Unit requires (3) size C/LR14 (1.5V) alkaline batteries (not included). ?

CAUTION:

Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes:

• Always keep batteries away from children.
• Never mix old and new batteries, or batteries of different brands or types.
• Always replace the entire set of batteries at one time.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked "rechargeable."
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Dispose of used batteries immediately.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the product into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.

This symbol ♻️ indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.

FCC Statement / CAN ICES-3 (B) / NMB-3(B)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1 this device may not cause harmful interference, and 2 this device must accept any interference received, including interference that may cause undesired operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Parts List

Assembly Instructions

The following describes the assembly steps based on the provided diagrams:

1. Battery Installation: Open the battery compartment cover (part 4). Insert three 1.5V C/LR14 batteries, ensuring correct polarity (+/-). Close the cover.
2. Attaching Rocker Runners: Slide the left rocker runner (part 1) onto the base of the seat. Repeat for the right rocker runner (part 2).
3. Attaching Rear Assembly: Connect the rocker rear assembly (part 3) to the seat base.
4. Attaching Seat Bottom Rest Assembly: Connect the seat bottom rest assembly (part 4) to the seat base.
5. Attaching Seat Back Rest Assembly: Connect the seat back rest assembly (part 5) to the seat base.
6. Securing Seat Pad: Place the seat pad (part 6) onto the seat. Fasten the buckles of the seat restraint system through the corresponding slots in the seat pad. Secure all hook-and-loop patches.
7. Attaching Bolster and Headrest: Place the bolster (part 7) and headrest (part 8) onto the seat pad and secure them.
8. Securing Harness: Ensure the harness straps are properly threaded through the seat pad and secured. Check that the buckles click into place.
9. Attaching Toy Bar: Attach the toy bar (part 9) to the designated points on the seat frame.

Using the Seat Restraint

Follow these steps to secure your baby:

1. Place the baby in the seat and thread the harness straps over the baby's shoulders.
2. Buckle the two shoulder straps into the buckle at the crotch.
3. Adjust the straps to fit snugly against the baby's body. Ensure the restraint system is secure but not too tight.

Using the Recline and Kickstand Functions

• Recline Function: Adjust the seat back to the desired recline position. The reclined position is for infants who cannot sit upright unassisted. Stop using the reclined position when the baby begins to sit up independently.
• Kickstand: The kickstand can be adjusted to two positions:
• Stationary Position: Locks the seat to prevent rocking.
• Rocking Position: Allows the seat to rock gently.

Music/Vibration Unit Operation

The music and vibration unit is powered by batteries (not included).

• Power: Press the Power button to turn the unit ON/OFF. The unit will automatically stop after 25 minutes.
• Nature Sounds: Press the Nature Sounds button to cycle through nature sounds and mute. Sounds play for approximately 25 minutes.
• Music: Press the Music button to cycle through music and mute. Music plays for approximately 25 minutes.
• Volume: Press the Volume button to adjust between Low, Medium, and High volume settings.
• Vibration: Press the Vibration button to turn the vibration function ON/OFF. Vibration operates for approximately 25 minutes.

Storage and Travel

The rocking seat can be folded for storage and travel. Ensure the unit is clean and dry before storing. Refer to the diagrams for folding instructions.

Contact and Support

For replacement parts, instructions, or support, please contact Kids2.

Find us on Facebook and Instagram @ingenuitybaby

Visit our website: ingenuitybaby.com