Ingenuity InLighten™ Soothing Swing - Dakota™

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

WARNING

FALL and STRANGULATION HAZARDS: Infants have suffered head injuries falling from seats and have strangled in straps.

• ALWAYS use the restraint system. Adjust to fit snugly.
• STOP using product when infant attempts to climb out (approximately 9 months).
• DO NOT use this product once your child can sit up unaided or weighs more than 9 kg/20 lbs. DO NOT use this product if your child weighs less than 3kg/6 lbs.
• Stay near and watch baby during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby as soon as possible and place baby on a firm, flat sleep surface such as a crib or bassinet. Never let the child sleep in this product.
• DO NOT move or lift this product with the baby inside it. Never lift product using a toy bar as a handle.
• ALWAYS place product on floor. NEVER use this product on an elevated surface (e.g. a table).
• NEVER attach any additional strings or straps to product or toy bar.

SUFFOCATION HAZARD: Young infants have limited head and neck control. If the seat is too upright, infant's head can drop forward and compress the airway.

• ALWAYS keep swing seat fully reclined until infant is at least 4 months old AND can hold up head without help.

SUFFOCATION HAZARD: Babies have suffocated when seats tipped over on soft surfaces.

• NEVER use on a bed, sofa, cushion, or other soft surface.

Prevent Serious Injury or Death

• NEVER leave the child unattended.
• To avoid injury ensure that children are kept away when unfolding and folding this product.
• Do not let children play with this product.
• When using the USB cord, only use the one supplied with this swing.
• Check the USB cord and wall adaptor regularly for damage. Do not use if any damage has occurred.
• Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.
• The product shall only be used with a transformer for toys.
• The transformer is not a toy.
• This product is only to be connected to equipment bearing either of the following symbols:
  [symbol: double square]
[symbol: triple line]
• Do not use extension cords.
• NEVER use as an infant carrier for automobile or airline travel.

CAUTION

This product contains small parts. Adult assembly required.

IMPORTANT

• The provided USB cord is 183cm in length.
• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts.
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
• This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.

Battery Information

The remote control requires a CR2032 (3V) battery (included).

The vibration Unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).

WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN. NEW AND USED BATTERIES ARE HAZARDOUS.

• Swallowing or placing a button battery inside the body may lead to death or serious injury in as little as 2 hours due to chemical burns and potential perforation of the esophagus.
• Medical attention should be sought immediately if you suspect a button battery has been swallowed or placed inside the body.
• Examine product and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if compartment is not secure.
• Dispose of used button batteries immediately and safely. Batteries can still be dangerous.

CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes:

• Always keep batteries away from children.
• Never mix old and new batteries, or batteries of different brands or types.
• Always replace the entire set of batteries at one time.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked "rechargeable.”
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Dispose of used batteries immediately.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the product into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.
• This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.

Care and Cleaning

• Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Bolster - Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
• Toys – Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame - Wipe the metal frame with a soft, clean cloth and mild soap.
• Storage - When putting swing away for storage, always store in a dry location, away from any heat sources, and out of the sun.

Parts List

Assembly Instructions

1. Step 1: Attach the left leg tube (2) and right leg tube (4) to the main frame (1). Ensure they are securely connected.
2. Step 2: Attach the left front foot (3) and right front foot (5) to the bottom of the leg tubes.
3. Step 3: Connect the swing arm assembly (6) to the main frame using screws (A) and nuts (B).
4. Step 4: Attach the cross brace assembly (7) to the leg tubes for added stability.
5. Step 5: Install the recline mechanisms (8 and 9) onto the swing arm.
6. Step 6: Attach the footrest tube (10) and back rest tube (11) to the swing arm assembly.
7. Step 7: Install the Vibe Unit (12) into its designated slot.
8. Step 8: Attach the Mobile with toys (13) to the top of the frame.
9. Step 9: Connect the USB cable (14) to the Vibe Unit and the power source.
10. Step 10: Place the Seat Pad (15) onto the seat.
11. Step 11: Attach the Head rest (16) and Bolster (17) to the seat pad.
12. Step 12: Attach the toys (18 and 19) to the mobile.
13. Step 13: Install the battery into the IR Remote (20).

Note: Refer to the diagrams for detailed visual guidance during assembly.

Using the Swing Control Module

The Swing Control Module allows you to operate the swing's functions:

• Power: Touch the Power switch to turn the module on or off.
• Swing Speed Control: Provides 5 speed settings and an OFF option. Touch the button until the LED bar graph displays the desired speed. The LEDs will flash for five seconds when adjusting speed.
• Timer Select: Set the swing timer for 30, 60, or 90 minutes. Three LEDs indicate the selected time. If no setting is selected, it defaults to 30 minutes.
• Nature Sounds/Music: Touch to play music and nature sounds. Touch again to select desired song or sound. Auto-shutoff occurs after approximately 20 minutes.
• Volume Control: Adjust the volume for music and nature sounds, or turn it off.
• Mobile Illumination: Press to start the mobile and turn on the lights. Press again for a random light/play pattern.

Using the Vibration Unit

To use the vibration function, push the button on the Vibe Unit to turn it on or off.

Using the Seat Restraint

Follow these steps to properly secure your baby in the swing:

1. Place the baby in the seat.
2. Fasten the shoulder straps and the waist belt.
3. Adjust the straps to ensure a snug fit.
4. Buckle the crotch strap.
5. Ensure all straps are securely fastened and adjusted properly.

Using the Recline Function

To adjust the recline of the seat, locate the recline adjustment lever on the side of the seat and move it to the desired position.

Rotation of the seat

To rotate the seat, press and hold the rotation button and turn the seat to the desired direction.

Storage and Travel

To store the swing, fold it by following the reverse steps of assembly. Store in a dry location away from heat and sun.

For travel, ensure the swing is securely folded and transported.

IR Remote Control

The IR remote control operates the swing's functions remotely. Ensure the battery is correctly installed in the remote.

FCC Statement / CAN ICES-3 (B) / NMB-3(B)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Déclaration FCC / CAN ICES-3 (B) / NMB-3(B)

Cet appareil est conforme à l'article 15 de la réglementation FCC. Son utilisation est sujette aux deux conditions suivantes : 1) ce dispositif ne peut causer d'interférences nuisibles, et 2) ce dispositif doit accepter toute interférence reçue, y compris les interférences pouvant causer un fonctionnement indésirable.

ATTENTION : Toute modification apportée à cet appareil, sans consentement explicite des responsables conformité, est susceptible d'annuler le droit d'usage de cet appareil.

REMARQUE : Cet article a été testé et déclaré conforme aux exigences requises pour les appareils numériques de classe B, conformément à l'article 15 de la réglementation FCC. Ces exigences visent à assurer une protection raisonnable contre les interférences nuisibles dans une installation chez des particuliers. Cet appareil génère, utilise et peut émettre de l'énergie radioélectrique, et s'il n'est pas installé et utilisé conformément aux instructions, il est susceptible de perturber les communications radio.

Nous ne pouvons garantir la non-interférence pour une installation donnée. Lorsque vous constatez que le matériel perturbe effectivement la réception radio ou télévision, vous pouvez vérifier ces interférences en éteignant et rallumant l'appareil. Dans ce cas, essayez une ou plusieurs des mesures suivantes :

• Réorientez ou déplacez l'antenne de réception.
• Éloignez l'appareil et le récepteur.
• Raccordez le matériel à une prise hors-circuit connexion de ce récepteur.
• Adressez-vous au fournisseur ou à un technicien expert en radio et télévision.