Project Source Refrigerator Water Filter - Model L-4-2
Thank you for purchasing this Project Source Refrigerator Water Filter. These instructions are designed to ensure a simple installation process. For more detailed information, please visit Lowes.com, search the item number, and refer to the Guides & Documents tab on the product page.
For assistance, contact customer service at 1-866-389-8827, Monday - Sunday, 8 a.m. - 8 p.m. EST, or email partsplus@lowes.com. You can also visit www.lowespartsplus.com.
Troubleshooting/Solución de Problemas
| Problem/Problema | Possible Cause/Causa Posible | Corrective Action/Acción Correctiva |
|---|---|---|
| Missing O-Ring/Falta una junta tórica | Manufacturer Error/Error del fabricante | Call Customer Service for replacement: 866-389-8827 |
| Leaking/Fugas | Improper Installation/Instalación inadecuada | Remove and reinstall, ensuring the filter is securely installed within the refrigerator housing. |
| Slow Flow/No Flow/Flujo lento/sin flujo | Improper Installation/Trapped Air Inside of the Filter/Instalación indebida/aire atrapado en el interior del filtro | Submerge filter without safety cap in a bowl or sink full of water for 45 minutes to 1 hour, reinstall. |
Care and Maintenance/Cuidado y Mantenimiento
Replace filter every 6 months or 200 gallons (757 liters), whichever comes first.
Warranty/Garantía
This replacement filter cartridge is warranted to be free from defects in material and manufacture for one (1) year from the date of purchase. This warranty does not cover failures resulting from abuse, misuse, alteration, or damage not caused by the manufacturer, or failure to follow proper installation and use instructions. If the product fails to satisfy this limited warranty during the described period, the manufacturer will replace or refund the purchase price of the product. This warranty does not cover additional costs such as labor.
Safety Information/Información de Seguridad
WARNING/ADVERTENCIA
To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer's specifications and instructions. Installation shall comply with applicable state and local regulations. For cold water applications only. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. This filter unit must be replaced every 6 months, at the rated capacity, or sooner if reduced water flow occurs. Failure to follow instructions and operating specifications will void your warranty. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product. Protect from freezing.
Installation Overview/Descripción General de la Instalación
- With the filter tabs in the horizontal position, insert the new filter into the housing head. Turn filter 1/4 turn clockwise. Push the filter upwards into the housing and close the cartridge cover.
- Pull the water filter down and rotate counter clockwise to remove it. Note: Be sure that the filter is completely downward prior to removing it out of the housing head.
- Carefully remove the sanitary cap from the top of the new filter.
- With the filter tabs in the horizontal position, insert the new filter into the housing head. Turn filter 1/4 turn clockwise. Push the filter upwards into the housing and close the cartridge cover. Note: Please ensure the filter is fully installed as it is required to activate the internal water valve. If the filter isn't properly installed, you may experience a slow flow or a chattering noise. If this occurs, please uninstall and reinstall the filter ensuring the filter is fully installed.
- Run approximately 2.5 gallons (9.46 liters) of water from the dispenser periodically to clear the system and to receive a good flow. If the water flow is slower than usual, please repeat Step 4. Note: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hours.
- Inspect the filter for any noticeable leaks. If leaks are detected, please repeat Step 4.
- To reset the filter monitor light, please refer to your refrigerator owner's manual for specific instructions.
Specifications/Especificaciones
- Flow Rate: 0.5 gpm (1.89 lpm)
- Operating Temperature: 33°-100°F (0.6°-38°C)
- Min Operating Pressure: 30 psi (207 kPa)
- Max Operating Pressure: 100 psi (689 kPa)
- Capacity: 6 months or 200 gallons (757 liters)
Certifications
This L-4-2 is Tested and Certified by NSF International against NSF/ANSI Standard 42 and 53 for the reduction of chlorine taste and odor, Endrin, Trichlorobenzene, p-Dichlorobenzene. Refer to performance data sheet for complete list of claims.
This L-4-2 is Certified by IAPMO R&T against NSF/ANSI 42, 53, 372, 401, P473 & CSA B483.1 for the reduction of chlorine taste and odor, Lead, Cyst, Mercury, Asbestos, Pharmaceuticals (such as Naproxen, Ibuprofen and Phenytoin), BPA, PFOA/PFOS, Endrin, Trichlorobenzene, p-Dichlorobenzene. Refer to Performance Data Sheet for complete list of claims.
The compounds under NSF/ANSI 401 have been deemed as 'incidental contaminants / emerging compounds'.
