Project Source Underwater Pool Vacuum

Package Contents

• 1. Standard Bag / Bolsa estándar
• 2. Main Body / Cuerpo principal
• 3. Vacuum Head / Cabezal de aspiradora
• 4. Female Connect Fitting / Conector hembra
• 5. Handle / Mango
• 6. Handle Pin / Pasador del mango
• 7. Garden Hose (sold separately) / Manguera para jardín (se vende por separado)
• 8. Telescopic Pole (sold separately) / Varilla telescópica (se vende por separado)

Assembly Instructions / Instrucciones de Ensamblaje

1. Place debris bag (1) over the top edge of the main body (2). Align the locking ring to the body and twist to lock.
2. Insert the vacuum head (3) into the bottom of the main body (2). Ensure the handle is positioned underneath the connector.
3. Press the female connect fitting (4) into the main body (2).
4. Attach the female connect fitting (4) to the garden hose (7).
5. Remove the handle pin (6) from the handle (5). Place the handle (5) onto the vacuum head fitting and align the holes. Slide the handle pin (6) through the holes.
6. Connect the telescopic pole (8) into the handle (5).

Note: Works with any standard pool pole with a 1 1/4in. diameter.

Operating Instructions / Instrucciones de Funcionamiento

To help prevent dirt and debris from lifting into the water during cleaning, loop the garden hose around the pole twice.

Connect the garden hose using the quick connect fitting into the body of the vacuum head.

Lower the vacuum head into the pool.

Turn the garden hose on to full pressure.

Vacuum the pool, allowing debris to collect into the mesh bag. Use the standard bag for normal leaves and debris. The fine mesh bag can be used to collect smaller particles.

When vacuuming is complete, turn the garden hose off. Remove the fine mesh bag and empty its contents into the trash.

Note: Good water pressure is important to provide the water flow into the mesh bag. Use a minimum 1/2in. diameter garden hose, no longer than 50ft., for best results.