Yeelight Sunset Lamp User Manual

Introduction

Please read this manual carefully before use and keep it properly.

Lamp Components (Front View):

• Charging port
• Light area
• ON/OFF Button
• Magnetic retractable base

Lamp Body Features:

• 360-degree adjustable lamp body
• 1/4 inch nut for universal tripod mounting

Note: The illustrations in this manual are schematic diagrams for reference only. Due to product updates and upgrades, the actual product may differ slightly from the diagrams. The actual product shall govern.

Operation

Press the button to turn on power and switch between modes.

Mode Switching:

• In the initial OFF mode, press once to reach the maximum light level.
• Press a second time to reach the minimum light level.
• Press a third time to turn off the light (normally closed mode).

These operations can be performed in cycles.

Mounting the Lamp

Method 1: Using Screws

1. Use a screwdriver to push out the two screw covers from the bottom of the base.

2. Screw the fixing screw for the base into the mounting position.

3. Fasten the screw cover.

Method 2: Using Tripod Mount

The lamp features a nut (1/4 inch nut) at its bottom, which is compatible with most tripods available on the market (tripods must be purchased separately).

Manufacturer Information

Manufacturer: QingdaoYeelink Information Technology Co., Ltd

Address: 10F-B4, Building B, Qingdao International Innovation Park, No.1 KeyuanWeiyi Road, Laoshan District, Qingdao City, Shandong Province, P.R.China

Website: www.yeelight.com

Customer Service Email: support@yeelight.com

Specifications

Model:

YLFWD-0006

Rated voltage:

5V 1A

Rated power:

3W

Operating temperature:

-10 to 40 °C

Operating humidity:

0%-85%RH

Dimensions:

82mm*82mm*95mm

Net weight:

About 300g

Warnings

1. Before use, please verify that the voltage conforms to the operating voltage of this product. Using an improper voltage may cause damage to the product and safety problems.
2. If the lamp does not turn on the first time you use it, please charge it.
3. Install and use the product in a place that is far away from heat sources, such as heating vents and conditioner vents, and that is not exposed to direct sunlight.
4. Make sure that the sensing area of this product is not covered by other objects. When cleaning the surface of the product, wipe it with a soft cotton cloth without using any corrosive solvents.
5. This product is not tested for waterproofing. Do not spray water on it or soak it in water to avoid any safety risks.
6. Do not use this product as a children's toy to avoid accidents.
7. For indoor use only.
8. The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or a similar qualified person.

Compliance and Disposal

Class III Luminaire

CE EU Declaration of Conformity

We QINGDAO YEELINK INFORMATION TECHNOLOGY CO., LTD., Hereby, declare that this equipment is in compliance with the applicable Directives and European Norms, and amendments.

WEEE Disposal and Recycling

Products bearing the WEEE symbol are waste electrical and electronic equipment. They should not be mixed with unsorted household waste. Protect human health and the environment by handing over your waste equipment to a designated collection point for recycling, appointed by the government or local authorities. Correct disposal and recycling help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location, terms, and conditions of such collection points.

Supplier's Declaration of Conformity (SDoC)

Equipment approved using SDoC is required to be tested. While it is not necessary to use an FCC-recognized accredited testing laboratory, the testing laboratory used must maintain records of measurement facilities as specified in Section 2.948 and records of measurements made as specified in Section 2.938.