MiBoxer PUSH3-2 2-Gang Wireless Dimming Panel (2.4GHz)
Model: PUSH3-2
Product Features
- Powered by CR2032 battery ?
- Easy wireless dimming via PUSH switch, no wiring required
- Compatible with MiBoxer / Mi-Light 2.4G series lighting fixtures
- Utilizes 2.4G RF wireless transmission technology with a control range of 30 meters ?
- Supports 2 independent control groups with unlimited light pairing
- Dimming range: 0.1% - 100%
Product Specifications
| Product Name | 2-Gang PUSH Wireless Dimming Panel (2.4GHz) |
|---|---|
| Model | PUSH3-2 |
| Input Voltage | 3V (CR2032 * 1PCS) |
| Transmit Power | 6dBm |
| RF | 2.4GHz ? |
| Control Distance | 30m ? |
| Working Temperature | -10°C ~ 40°C ?️ |
| Standby Power | <6μA ⚡ |
| Waterproof Rating | IP20 ? |
| EMC Standard (EMC) | ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-3 V2.1.1 |
| Safety Standard (LVD) | EN 61347-1:2015+A1: 2018 EN 61347-2-11: 2001+A1:2019 |
| Radio Equipment (RED) | ETSI EN 300 440 V2.2.1 |
| Certifications | CE, EMC, LVD, RED |
Image of the MiBoxer PUSH3-2 wireless dimming panel. Dimensions diagram showing the panel is 86mm x 86mm, with a thickness of 14.5mm. It indicates '1 Group' and '2 Groups'.
Dimming Control
- Short press to turn lights on/off ▶️/⏹️, long press to adjust brightness ?.
- Supports 2 independent control groups, with unlimited light pairing ?.
Installation Instructions
Battery Installation
- Remove the top cover.
- Install the CR2032 battery (sold separately).
- Attach the top cover.
Adhesive Mounting
- Peel off the protective paper from the double-sided tape.
- Paste onto a flat wall surface at the desired position.
Screw Mounting
- Remove the top cover.
- Position the panel, then secure it with screws and replace the top cover.
Pairing Instructions
To pair the panel with your lights:
- Disconnect power to the light, then reconnect it after 10 seconds.
- Within 3 seconds of reconnecting power, short press the "Group" button 6 times.
- The light will slowly flash 3 times, indicating successful pairing.
⚠️ If the light does not flash slowly, pairing has failed. Please repeat the steps above. (Note: Lights already paired do not need to be paired again.)
Unpairing Instructions
To unpair the panel from your lights:
- Disconnect power to the light, then reconnect it after 10 seconds.
- Within 3 seconds of reconnecting power, short press the "Unlink" button 5 times.
- The light will flash quickly 10 times, indicating successful unpairing.
⚠️ If the light does not flash quickly, unpairing has failed. Please repeat the steps above. (Note: Lights not yet paired do not require unpairing.)
