The Wythe Bed

Included Components & Hardware

The following components and hardware are included for assembly:

• Headboard (1)
• Footboard (1)
• Side Rails (2)
• Center Support Rail (1)
• Center Support Legs (3)
• Slats (Queen & King: 14; California King: 15)
• Washers (8)
• Nuts (8)
• Wrench (1)

Diagrams show individual components: a headboard, two side rails, a footboard, a center support rail, three center support legs, slats, washers, nuts, and a wrench.

Notes

Assembly requires 2 people. When installing this bed, ensure all hardware is firmly secured. Do not loosen or move hardware.

Assembly Steps

Step 1: Prepare Side Rails

Locate the zipped panels on the side rails and open them to access the assembly hardware that connects the headboard and side rails.

Illustration shows the headboard and side rails with zipped panels open, indicating where the connection hardware is located.

Step 2: Attach Headboard

Insert the pre-attached bolts on the headboard into the side rails. Once inserted, place a washer and nut onto each bolt, and use the wrench to tighten them.

Close-up illustrations show bolts from the headboard being inserted into the side rails, followed by the placement of a washer and nut, and tightening with a wrench.

Step 3: Prepare for Footboard Attachment

Once the headboard and side rails are connected, locate the zipped panels on the opposite ends of the side rails and open them to access the assembly hardware that connects the footboard and side rails.

Illustration shows the assembled headboard and side rails, with zipped panels on the side rails near the footboard end opened to reveal connection points.

Step 4: Attach Footboard

Insert the pre-attached bolts on the footboard into the side rails. Once inserted, place a washer and nut onto each bolt, and use the wrench to tighten them.

Close-up illustrations show bolts from the footboard being inserted into the side rails, followed by the placement of a washer and nut, and tightening with a wrench.

Step 5: Install Center Support Legs

Screw the center support legs into the center support rail, with the metal T-nuts facing upward.

Illustration shows the center support rail with three center support legs being screwed into it, with arrows indicating the T-nuts should face upwards.

Step 6: Position Center Support

Place the center support rail inside the bed frame and adjust the glides on the center support legs as needed, ensuring the legs stand straight and are flush to the floor. Check to ensure the zipped panels are closed.

Illustration shows the bed frame with the center support rail and legs installed. It depicts adjusting the leg glides to ensure they are flush with the floor and the frame is stable. Zipped panels are shown closed.

Step 7: Place Slats

Place the slats inside the bed frame. Note that the slat pocket is designed to be slightly wider than the slat for ease of assembly.

Illustration shows the bed frame with the center support rail in place, and the slats being laid across the frame. It highlights the slat pockets.

Bed Configurations

The illustrations below display the various configurations of the Wythe Bed.

Queen & King

14 Slats

Illustration of a Queen or King size Wythe Bed frame with 14 slats arranged across the support rail.

California King

15 Slats

Illustration of a California King size Wythe Bed frame with 15 slats arranged across the support rail.

Assembly Checklist

Review the checklist below to ensure your bed is properly assembled.

• ☐ Ensure all slats are present.
• ☐ Ensure all slats are lying flat.
• ☐ Ensure all hardware is firmly secured. Do not loosen or move hardware.
• ☐ Ensure center support legs are level.
• ☐ Ensure the mitered corners are flush with each other.
• ☐ Should you need to move this piece for any reason—including installing a rug beneath it—disassemble it first, then reassemble in the desired position.