Aura Light Kleva Installation Manual

Intended use:

The luminaire is intended for standard use in dry environments. The luminaire is not suitable for outdoor environments.

Safety instructions:

These instructions assume expert knowledge corresponding to a completed professional education as an electrician. Never work when voltage is present on the luminaire. Caution - Risk of fatal injury! Ensure that the luminaire is undamaged before installation and commissioning! The manufacturer is not liable for any damage caused by incorrect or unauthorized use or by non-observance of these instructions. Work on the luminaire (installation, maintenance, servicing, troubleshooting) may only be carried out by authorized electrician.

DALI: Basic insulation between supply-and control terminals.

5-Year warranty policy

Aura Light offers a 5-year warranty regarding manufacturing and material defects in products manufactured and/or sold by Aura Light, provided that the product information for the product in question in digital form via www.auralight.com, or in physical form via printed mailings by Aura Light, refers to this warranty policy.

Installation Steps

1. Loosen screw. Do not remove! Note: accessories inside the luminaire.
2. Move endcap 5 mm.
3. Remove shade.
4. Attached inside the luminaire.
5. Cable installation.
6. Cable installation.
7. Click (2x). Cable installation.
8. Slide reflectors (2x).
9. Important! Reflector, Reflector, Reflector
10. Attach shade.
11. Move endcap 5 mm.
12. Note: Tighten the screw carefully.
13. Shade.

Internal through-wiring only for 1200mm length (pre-installed).

1. Cable.
2. Cable installation (2x).
3. Slide outer reflectors (2x).
4. Important! Reflector, Reflector, Reflector
5. Tighten screw.
6. Shade.

Centre through-wiring only for 1200mm length

1. Use attached cable clamp and screws (3x). Cable installation.
2. Reflectors (3x). Cable installation. Peel off installation cable.
3. Important! Reflector, Reflector, Reflector
4. Tighten screw.
5. Shade.

Dimensions

• 600mm model: 625mm length, 66mm height, 110mm width. Flexible (min 300 mm C:C) mounting. 4 ceiling brackets.
• 1200mm model: 1185mm length, 66mm height, 110mm width. Flexible (min 600 mm C:C) mounting. 4 ceiling brackets. Cable entries: 43mm (x3), 24mm (x1).

Product Information

The luminaire contains a control gear and a replaceable LED light source that shall only be replaced by manufacturer.

Note: Kleva is meant for indoor use, in non-heated and heated environments (-25) - (+40). For example: Garage, factories, stairways, corridors, washrooms. IP44 = Protected against light dust and water splash. For rougher environments where high protection is needed, Aura Light recommends solutions with IP65 classification.

Technical information can be found @ www.auralight.com

Installation movie available.