Introduction and Safety Information
Please read this instruction manual carefully before attempting to install. Assembly is recommended for 1 or more people (?) and is expected to take approximately 1 hour (⏰). This product is not intended for use by children (??) and should be kept away from fire or heat sources (?❌). Wearing protective gloves (✋✔️) is recommended during assembly.
Visual guide showing correct and incorrect assembly preparation. The incorrect method shows a person placing a box directly on the floor and then on the product, with a red cross (❌). The correct method shows a person placing a protective pad or cover on the floor before placing the product components, with a green checkmark (✔️).
Parts List
| Item Number | Description | Quantity |
|---|---|---|
| 1 | Hex Key | x1 |
| 2 | Screw (M6x50mm) | x4 |
| 3 | Screw (M6x30mm) | x2 |
| 4 | Screw (M6x35mm) | x27 |
| 5 | Screw (M8x60mm) | x1 |
| 6 | Screw (M8x50mm) | x5 |
| 7 | Base Board | x1 |
| 8 | Middle Platform | x1 |
| 9 | Top Platform | x1 |
| 10 | Ramp | x1 |
| 11 | Hanging Basket | x1 |
| 12 | Round Perch | x1 |
| 13 | Small Condo Box | x1 |
| 14 | Large Condo Box | x1 |
| 15 | Sisal-wrapped Post (32cm) | x1 |
| 16 | Sisal-wrapped Post (42cm) | x1 |
| 17 | Sisal-wrapped Post (20cm) | x1 |
| 18 | Wooden Post (21cm) | x8 |
| 19 | Wooden Post (32cm) | x3 |
| 20 | Small Connector Tube (8.5cm) | x4 |
| 21 | Wooden Post (22cm) | x1 |
| 22 | Wooden Post (40cm) | x1 |
| 23 | Hanging Toy Ball with Bell | x1 |
| 24 | Screw (M6x40mm) | x1 |
| 25 | Hammock | x1 |
| 26 | Oval Perch | x1 |
Assembly Instructions
Step 1
Assemble the large condo box (14) by attaching four wooden posts (18) to its corners using eight screws (4). The screws are inserted through the outer panels into the posts.
Step 2
Assemble the small condo box (13) by attaching four wooden posts (18) to its corners using eight screws (4). The screws are inserted through the outer panels into the posts.
Step 3
Attach one sisal-wrapped post (15) and two wooden posts (19) to the base board (7) using three screws (4). The screws are inserted from the underside of the base board into the posts.
Step 4
Assemble the ramp (10) to the angled platform (9) using two parts (3) and four screws (2). Important note: During assembly, please first half-tighten all screws. After all screws are set, fully tighten them.
Step 5
Attach the assembled large condo box (14) to the angled platform (9) using one screw (5). Then, place this combined unit onto the two wooden posts (19) that are already attached to the base.
Step 6
Attach two wooden posts (19) using screws (6). Attach one sisal-wrapped post (16) using screw (6). Attach one connector tube (20) using screw (4).
Step 7
Attach one middle platform (8) to the structure using one screw (4) and one connector tube (20).
Step 8
Attach the long wooden post (22) using screw (6). Attach two connector tubes (20) using screws (6). Attach one middle platform (8) using screw (4).
Step 9
Attach the assembled small condo box (13) to the structure using three screws (4) and two connector tubes (20). Important note: Repeat the advice to half-tighten all screws first, then fully tighten them once all are in place.
Step 10
Attach one sisal-wrapped post (17) using two screws (4). Attach one connector tube (20) using screw (4).
Step 11
Attach the hammock (25) to the structure using one screw (4) and one part (6). Attach the oval perch (26) to the structure using one screw (4) and one connector tube (20).
Step 12
Attach the hanging basket (11) to the structure using the basket itself and one wooden post (21). Attach the round perch (12) to the structure using the perch itself and one wooden post (21).
Step 13
Attach the hanging toy ball (23) to the structure using one screw (24). Note: Please remove the bell(s) from the hanging toy balls if your cats tend to eat foreign objects.
Product Care Instructions
1. Wipe the outer surface with a soft, clean cloth or sponge to remove dust and dirt.
2. Avoid chemical cleaners or harsh solvents to prevent damage to the product's appearance.
3. Inspect fittings (bolts, screws, nuts, etc.) every 3 months and re-tighten them every 6 months.
4. Avoid direct sunlight.
If the product shows structural damage or poses a safety hazard, stop using it until it is repaired.
Customer Support
If you are not entirely satisfied with your purchase, please feel free to contact us using the following steps:
- Go to Your Orders.
- Find your order in the list.
- Select 'Problem with order'.
- Choose your topic from the list displayed.
- Select 'Contact seller'.
Contact Information:
- US: YAHEE TECHNOLOGIES CORP, Address: 1532 S VINEYARD AVE ONTARIO CA 91761
- UK: Monumart Limited, Address: Europa House, Europa Way, IP15DL, Ipswich.
- France: Yahee SAS, Adresse: 6, Place de la Madeleine, 75008 Paris.
- Italy: Yahee SRL, Indirizzo: Via Generale Gustavo Fara, 26, 20124 Milano.
Download Manual
You can also download the electronic Installation Manual from the Product guides and documents section of the advertising page.
