Yaheetech 592647 Ocean-Themed Cat Tree Assembly Instructions

Important Information

Please read this instruction manual carefully before attempting to install.

Assembly Recommendations:

• ? Recommended: 1 or more people for assembly.
• ⏱️ Estimated assembly time: 1 hour.
• ?? Not intended for use by children.
• ? Keep away from fire or other heat sources.
• ? We recommend wearing protective gloves during assembly.

Please follow the instruction manuals and use a pad or protective covering to avoid damage to the product and floor during assembly.

Parts List

Assembly Instructions

Step 1

Attach posts (15) to the cylindrical condo/base (5). Use 3 screws (A) for each of the two posts (15), totaling 6 screws (A). The diagram shows two posts (15) being attached to the sides of part (5).

Parts used: (5) x1, (15) x2, (A) x6

Step 2

Attach posts (12) and (14) to the large base platform (1). Use screws (A) for attachment. Ensure correct orientation of Part (1). The diagram shows two long posts (12) and two short posts (14) being attached to the underside of platform (1).

Parts used: (1) x1, (12) x2, (14) x2, (A) x4

Step 3

Attach posts (10) to the medium base platform (2). Use screws (B) for attachment. Ensure correct orientation of Part (2). The diagram shows three short posts (10) being attached to the top side of platform (2).

Parts used: (2) x1, (10) x3, (B) x4

Step 4

Attach the fish-shaped platform (8) and the small platform (3) to the assembled structure. Use screws (A) to attach the fish platform (8) to a post. Use screw (B) to attach the small platform (3) to a post.

Parts used: (3) x1, (8) x1, (13) x1, (A) x2, (B) x1

Note: The diagram shows platform (3) being attached to a post using screw (A), and platform (8) being attached to a post using screw (B). Part (13) is also shown being attached.

Step 5

Attach the cylindrical condo/base (5) to the structure. Use screw (C) for attachment.

Parts used: (5) x1, (C) x1

Step 6

Attach the top platform (7), the medium sisal post (11), and the ring-shaped piece (4) to the structure. Use screw (A) for attachment.

Parts used: (4) x1, (7) x1, (11) x1, (A) x1

Step 7

Attach the small perch/platform (6) and the top dome/enclosure (9) to the structure. The diagram shows the dome (9) being placed on top and the perch (6) being attached to the side.

Parts used: (6) x1, (9) x1

Note: The diagram shows the dome (9) being attached to the top of the structure, and the perch (6) being attached to the side, possibly using part (2) as a reference point.

Step 8

Secure the final assembly. Use screws and washers (D) for final tightening or securing points.

Parts used: (D) x1

Customer Support & Downloads

If you are not entirely satisfied with your purchase, please feel free to contact Yaheetech customer service by following these steps:

1. Go to Your Orders.
2. Find your order in the list.
3. Select "Problem with order".
4. Choose your topic from the displayed list.
5. Select "Contact seller".

You can also download the electronic Installation Manual from the product guides and documents section of the advertising page.