Reznor Reflector Side Extension Kit Installation
For Gas-Fired Low-Intensity Radiant Tube Heaters
Revision: VZ-VZH-CD28 (06-24) 1047440-0
Supersedes: Original Version
Option CD28 for Models VZ and VZH
NOTE: If the installation requires side extensions to reflect heat in a desired direction, refer to these instructions along with the installation manual provided with the heater for complete heater installation instructions.
- Refer to the installation manual provided with the unit for important safety information.
- Ensure that all components shown in Figure 1 and listed in Table 1 are available before beginning installation.
Figure 1. Reflector Side Extension Installation
[Diagram Description: A schematic illustration shows a section of a radiant tube heater with a reflector side extension attached. Numbered components are indicated: 1. Support bracket, which attaches to the heater tube. 2. Reflector side extension, a curved metal piece designed to direct heat. It features notches for clearance. 3. Retainer clip, used to secure the extension. 4. Sheet metal screw, used with the retainer clip. The diagram shows how these parts connect to form the side extension assembly.]
Table 1. Reflector Side Extension Kit (PN 02712700) Components
| Item No. | Component | PN (Quantity) |
|---|---|---|
| 1 | Support bracket, reflector side extension | 01329911 (2)* |
| 2 | Reflector side extension, 96-inch (244 cm) | 01368000 (1) |
| 3 | Retainer clip | 02751200 (2) |
| 4 | Sheet metal screw, #8 x 3/8 | 94118106 (2) |
*Quantity is two (2) per side extension. Use additional support brackets as necessary for installation locations with high air movement.
Installation Instructions
- Install support brackets (1) as shown in Figure 1 and tighten wingnut on each bracket to secure bracket to tube.
- Cut notch(es) as necessary in reflector side extension (2) as shown in Figure 1 to provide clearance for suspension hardware.
- Slide bottom of reflector side extension (2) through support brackets (1) as shown in Figure 1 and secure retainer clips (3) at top of side extension to reflector using sheet metal screws (4).
