Zyxel GM4100-B0 G.fast 212 MHz VDSL2 Bridge

Support Information

For more information, customer support, and safety warnings, see the User's Guide at www.zyxel.com.

EU Importer: Zyxel Communications A/S, Gladsaxevej 378, 2. th. 2860 Søborg, Denmark. https://www.zyxel.com/dk/da/

Copyright © 2022 Zyxel and/or its affiliates. All Rights Reserved.

Hardware Installation

Step 1: Use a phone cable to connect the G.fast port to a DSL splitter or directly to the telephone wall outlet.

Step 2: Connect a computer or Access Point to a LAN port using an Ethernet cable.

Step 3: Use the included power adapter to connect the POWER socket to an appropriate power source. Press the ON/OFF button to turn on the Zyxel Device.

Step 4: Check that the LED lights are already on.

LED Status Indicators:

• POWER
  • Green Blinking: The Zyxel Device is booting, getting ready for use.
  • Green On: The Zyxel Device is ready for use.
  • Red Blinking: Firmware upgrade is ongoing.
  • Red On: System failure.
• G.fast
  • Green On: G.fast / VDSL2 / ADSL 2(+) link is up.
  • Green Blinking (slow): Link is down and trying to detect carrier signal.
  • Green Blinking (fast): Initializing the link.
• Ethernet LAN 1 & 2
  • Green On: Ethernet is ready.
  • Green Blinking: Transmitting/receiving LAN data.

Wall Mounting (Optional)

Drilling Guide:

Use the Quick Start Guide to mark the holes for drilling. Drill two holes in the wall at a distance of 80 mm. Use a 6.0-6.5 mm drill bit to drill two holes to a depth of 32 mm. Insert screw anchors and screws (not provided).

Mounting:

1. Place the Zyxel Device so the wall mount holes line up with the screws.

2. Slide the Zyxel Device down gently to fix it into place.

* Do not mount this Zyxel Device higher than 2 m on a wall.