Bobtot

What's in the Box

Check to make sure you have everything below.

• A: 1x Cutie Portable Speaker
• B: 1x USB Charging Cable (Type-C)
• C: 1x Quick Start Guide

Device Overview

The top of the speaker features several controls:

• 1. Power On/Off button
• 2. Play/Pause button
• 3. Volume Down/Previous Button
• 4. Answer/Reject/Redial the call button
• 5. Volume Up/Next Button

Buttons and Ports

Power On/Off: Long press ? to turn the speaker on/off.

Play/Pause: Short press ▶️/⏸️ to play/pause. Long press to disconnect BT mode.

Volume Down/Previous Button: Short press ⏪ to go to the previous song. Long press to decrease the volume.

Answer/Reject/Redial the call: Short press ? to answer the call. Long press to reject the call. Double-click to redial the last number.

Volume Up/Next Button: Short press ⏩ to go to the next song. Long press to increase the volume.

Charging Your Device

Plug the included USB Type-C cable into the speaker's charging port and connect the other end to a power adapter (not included). It takes approximately 4 hours to fully charge the battery.

Indicator light status:

• Charging: Solid red light
• Fully Charged: LED light turns off

Note: Bobtot recommends using a USB wall adapter with a DC 5V/2A output.

Device Information: Model: Cutie, FCC ID: 2AYL8-BT2602A

The charging port is USB Type-C.

Initial Setup

Follow these steps to connect your speaker via Bluetooth:

1. Once your speaker is fully charged, press and hold the Power button ? until you hear a voice prompt indicating the device has entered BT pairing mode.
2. On your smartphone or tablet, search for the Bluetooth device named "Cutie" and tap to connect.
3. The speaker will play a prompt once pairing is successful.

Hands-Free Calling

Answer Button ?:

• Short press to accept an incoming call.
• Long press to reject an incoming call.
• Double-click to call back the last number.

Volume Down ⏪: Long press once to decrease volume.

Volume Up ⏩: Long press once to increase volume.

Resetting Your Device

If your speaker is not operating properly, you can reset it. Press and hold the power button ? for approximately 12 seconds until the speaker powers off, then power it on again as usual.

Specifications

• Model Name: Cutie
• Product Type: Portable Wireless Speaker
• Output Power: 5W
• Input Power: DC 5V 2A
• Frequency Response: 180Hz-18KHz
• Wireless Range: 33ft (10m)
• Charging Time: 4 hours
• Features: Water-resistant, sprayproof, Built-in rechargeable battery

FCC Compliance Information

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.

Need Help?

Customer Care Guide

Bobtot strives to provide exceptional customer care. Building strong relationships with customers is essential to the business.

Customer Support

Time: Bobtot aims to respond to all inquiries within 24 hours.

Feedback: Bobtot values customer feedback and encourages sharing thoughts and ideas.

Solutions

If customers encounter issues, Bobtot will work to find quick and efficient solutions. Bobtot takes customer care seriously, prioritizing customers and committed to providing high-quality service.