Bobtot Triangle Outdoor Portable Wireless Speaker

What's in the Box?

Check to make sure you have everything below:

• A: 1*Triangle Portable Speaker
• B: 1*USB Charging Cable (Type-C)
• C: 1*Quick Start Guide
• D: 1*Handy Carry Strap

Device Overview

The speaker features a charging port, indicator light, and microphone.

Buttons and Ports:

• Power/TWS: Long press to turn the speaker on/off. Double click to initiate TWS pairing or disconnect from two speakers.
• Volume Down/Previous Button: Short press to turn down the volume. Long press to go to the previous song.
• Volume Up/Next Button: Short press to turn up the volume. Long press to go to the next song.
• Play/Pause/Answer Button: Short press to pause/play music. Short press to accept an incoming call. Long press to reject an incoming call. Long press for 2s to disconnect from Bluetooth. Double click to call back.

Charging Your Device

Plug the included USB Type-C cable into the speaker's charging port and connect the other end to a power adapter (not included). Allow approximately 2.5 hours for a full charge. The indicator light is red while charging and turns off when fully charged.

Note: It is recommended to use a USB wall adapter with a DC 5V=1A output.

Initial Setup

1. Once your speaker is fully charged, press and hold the Power button until you hear a voice prompt indicating the device has entered BT pairing mode.
2. On your smartphone or tablet, search for the BT device named "Triangle" and tap to connect.
3. A prompt will play once pairing is successful.

Notes:

• If the speaker is turned on but not connected, it will automatically shut down after 10 minutes.
• If connected but no playback occurs, it will automatically shut down after 20 minutes.

TWS Sync Mode

1. Long press the Power/TWS button for about 2 seconds on both speakers to turn them on. The blue indicator light will flash.
2. Quickly double-click the Power/TWS button on either speaker. A prompt sound "connected" indicates the speakers have entered pairing mode, and the indicator light of one speaker will turn solid blue.
3. On your smartphone or tablet, search for the BT device named "Triangle" and connect it. You will hear the sound "connected" again, signifying a successful connection. You can now enjoy music with both speakers simultaneously.

Notes:

• In TWS Mode, turning off one speaker will turn off both.
• Double-clicking the Power/TWS button will disconnect the TWS pairing.

Hands-Free Calling

• Short press the Answer Button to accept an incoming call.
• Long press the Answer Button to reject an incoming call.
• Long press for 2 seconds to disconnect from Bluetooth.
• Double click the Answer Button to call back the last number.

Resetting Your Device

If your speaker is not operating properly, you can reset it. Press and hold the power button for approximately 8 seconds until the speaker powers off, then power it on again as usual.

Specifications

• Model Name: Triangle
• Product Type: Outdoor Portable Wireless Speaker
• Input Power: 5V - 1A
• Impedance: 4Ω
• Signal to Noise Ratio: > 78dB
• Water Resistance: IPX7 water-resistant, sprayproof
• Battery: Built-in rechargeable battery
• Microphone: Built-in Mic
• Range: 33ft (10m)
• Frequency Response: 180Hz-12KHz
• TWS Sync Mode: Pair 2 of these speakers together
• Playtime: Up to 10 hours of playtime (battery life measured with volume set at 50%)

FCC Warning

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC ID: 2AZ43-ET2240A

Customer Care Guide

At Bobtot, we strive to provide exceptional customer care. We believe that building strong relationships with our customers is essential to our business success. To help us achieve this goal, we have put together the following customer care guide:

• Time: We will respond to any inquiries within 24 hours.
• Feedback: We value your feedback and encourage you to share your thoughts and ideas.
• Solutions: If you encounter any issues, we will try our best to find a quick and efficient solution.

If you have any questions or concerns, please do not hesitate to reach out to us. We will be happy to assist you:

• Call or Message: +1 888 572 1718
• Email: service@bobtot.net
• Website: bobtot.net