V-TAC Garden Spike Lamp Outdoor Series
Instruction Manual
WEEE Number: 80133970
Technical Data
| Model | VT-1119 |
| SKU | 10372 |
| Rated Load | 35W |
| Base | GU10 (Bulb not included) |
| Material | Aluminium |
| Dimension | Φ75x88x245mm |
| Input Voltage | AC: 220-240V, 50Hz |
Introduction
Thank you for selecting and buying a V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 hours daily operation. Usage of product for 24 hours a day would void the warranty. This product is warranted for manufacturing defects only.
Warnings
- Please make sure to turn off the power before starting the installation.
- Installation should only be done by a certified electrician.
- Proper grounding should be ensured throughout the installation.
- Waterproof box not included.
♻️ This marking indicates that this product should not be disposed of with other household wastes.
⚡ Caution, risk of electric shock.
Installation
Installation Diagram Description
The installation process is illustrated in six steps:
- Ensure the power switch is in the OFF position.
- Disassemble the lamp by removing the front ring and screws.
- Install the GU10 light source into the lamp holder.
- Insert the spike into the ground at the desired location.
- Connect the wiring according to the diagram: Neutral (N), Earth (ground symbol), and Live (L).
- Connect the wires to the power supply terminals, ensuring the power is ON.
Installation Instructions
- Turn off the power switch.
- Remove the front ring of the lamp.
- Install the light source (GU10).
- Assemble the lamp and spike.
- Connect to the power supply according to the drawing.
- Switch on the power if all the above steps are done properly without any mistakes.
Contact Information
For any query/issue with the product, please reach out to us at: SUPPORT@V-TAC.EU
For more products range, inquiry please contact our distributor or nearest dealers.
V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B
