V-TAC VT-7614 Bollard Lamp Installation Instructions

Technical Data

IP54 Rating

Introduction & Warranty

Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.

For more products range, inquiry please contact our distributor or nearest dealers. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B

In case of any query/issue with the product, please reach out to us at: SUPPORT@V-TAC.EU

Warnings

• Please make sure to turn off the power before starting the installation.
• Installation must be performed by a qualified electrician.
• Proper grounding should be ensured throughout the installation.
• Must be connected to waterproof terminal box.
• Caution, risk of electric shock.
• This marking indicates that this product should not be disposed of with other household wastes.

Installation Diagram

[Diagram showing the steps for installing the bollard lamp, including drilling holes, fixing the base, connecting wires, and attaching the lamp body.]

Wiring Diagram

[Diagram showing the wiring connections: Ground, Blue wire (N), Brown wire (L).]

Installation Instruction

1. Switch off the main power.
2. Drill two holes on the floor and insert two plastic expansion bolts in it.
3. Fix the base on the plastic expansion piece with self-tapping screws.
4. Connect the supply leads with the terminal.
5. Fix the lamp body on the plate and tighten the screws.
6. To fit the Light, Rotate the top cover clockwise and place the GU10 Lamp on the holder.
7. Place the top cover back by rotating anti-clockwise.
8. Switch on and test the light.

Important Notes (WEEE Disposal)

Electrical and electronic equipment that has become waste is referred to as waste equipment. Waste equipment must not be disposed of with other household waste.

Owners of waste equipment at the end of its useful life must return the equipment to the collection points set up by public disposal authorities or dealers. This return is free of charge for you.

Owners of waste equipment are obliged to remove lamps from the waste equipment non-destructively before returning them.

The “crossed-out garbage can” symbol indicates that this product must not be disposed of with other household waste and must be collected separately from unsorted household waste at the end of its life.

When disposing of electrical equipment in landfills or dumps, pollutants can enter the groundwater and get into the food chain and damage your health and well-being.

You can find the online directory of collection and return points at the following link: https://www.ear-system.de/ear-verzeichnis/sammel-und-ruecknahmestellen