Notice de programmation télécommandes Auto-Apprentissage
LEADER DE LA VENTE DE TELECOMMANDES SUR INTERNET
Principe du codage par auto-apprentissage d'une télécommande (générique)
ATTENTION:
This section provides a general description of the procedure for registering a new auto-learning remote control. This description may not exactly match all brands and models. Please refer to your original manual.
Notice modèle déposé ® reproduction intégrale sans aucune modification autorisée. PAC 2010
Each remote control has a unique "radio signature", and the radio receiver is capable, depending on the model, of registering 1 to several thousand "radio signatures", thus as many remote controls.
Procédure générique:
- Open the radio receiver (follow the antenna wire to locate the radio receiver).
- Press the push button, labeled: MEMO, REC, ENR, or PROG, on the radio card.
- NB: For some receivers, it is enough to press the MEMO button once and release it; for others, you must keep the MEMO button pressed.
- A light on the radio card will illuminate or flash.
- Press the button on your new remote control for 1 second.
- Release the button.
- Wait for the light on the radio card to turn off.
- Test the remote control.
- Close the radio receiver.
ATTENTION:
For certain radio receiver models, keeping the MEMO button pressed for more than 5 seconds will erase all remote controls already registered by the receiver!
Principe du codage par auto-apprentissage d'une télécommande (générique)
ATTENTION:
This section provides a general description of the procedure for registering a new auto-learning remote control. This description may not exactly match all brands and models. Please refer to your original manual.
Notice modèle déposé ® reproduction intégrale sans aucune modification autorisée. PAC 2010
Each remote control has a unique "radio signature", and the radio receiver is capable, depending on the model, of registering 1 to several thousand "radio signatures", thus as many remote controls.
Procédure générique:
- Open the radio receiver (follow the antenna wire to locate the radio receiver).
- Press the push button, labeled: MEMO, REC, ENR, or PROG, on the radio card.
- NB: For some receivers, it is enough to press the MEMO button once and release it; for others, you must keep the MEMO button pressed.
- A light on the radio card will illuminate or flash.
- Press the button on your new remote control for 1 second.
- Release the button.
- Wait for the light on the radio card to turn off.
- Test the remote control.
- Close the radio receiver.
ATTENTION:
For certain radio receiver models, keeping the MEMO button pressed for more than 5 seconds will erase all remote controls already registered by the receiver!
