Notice de programmation

TELECO 433

Programming from an existing remote control:

Take a remote control that is already in use and a new remote control. The operation is performed by placing yourself next to the gate (within the radio receiver's range).

Existing remote control	New remote control
Press the hidden button on an existing remote control. The receiver emits beeps.	Press the button used on the existing remote control. The receiver emits a beep: the receiver enters "memorization" mode for 5 seconds.	Press the same button. The receiver emits beeps confirming the registration of the new remote control.
[Image description: An existing remote control is shown with an arrow pointing to a small hidden button, possibly a battery compartment release. The text 'ALKALINE' is visible on a battery. Another arrow points to a small button on the side of the remote. Example	[Image description: A new remote control is shown with an arrow pointing to one of its buttons, labeled 'Exemple'.] Example	[Image description: Another new remote control is shown with an arrow pointing to one of its buttons, labeled 'Exemple'.] Example

Existing remote control

New remote control

Press the hidden button on an existing remote control. The receiver emits beeps.

Press the button used on the existing remote control. The receiver emits a beep: the receiver enters "memorization" mode for 5 seconds.

Press the same button. The receiver emits beeps confirming the registration of the new remote control.

[Image description: An existing remote control is shown with an arrow pointing to a small hidden button, possibly a battery compartment release. The text 'ALKALINE' is visible on a battery. Another arrow points to a small button on the side of the remote.

Example

[Image description: A new remote control is shown with an arrow pointing to one of its buttons, labeled 'Exemple'.]

Example

[Image description: Another new remote control is shown with an arrow pointing to one of its buttons, labeled 'Exemple'.]

Example

ATTENTION: A "TAK" version exists, with a BLACK casing, reserved for collective installations, non-compatible.

	Programming a Dip-Switch Remote Control \| Allo Télécommande Learn how to program a dip-switch remote control for your installation. This guide provides step-by-step instructions on coding your remote.
	Programming Guide for Allo Telecommande V2 Remote Controls This guide provides instructions for programming Allo Telecommande V2 remote controls with the RX WALLY and RXP receivers. It covers the steps for registering new remotes, selecting channels, and confirming the programming process.
	Programming Auto-Learning Remote Controls A guide to programming auto-learning remote controls, providing generic procedures and important attention points for successful setup.
	Allo Telecommande Product Exchange Form Under Warranty Formulaire d'échange pour produit sous garantie from Allo Telecommande. This document outlines the steps for returning a product for exchange under warranty, including required information and shipping instructions.
	Programming Notice for ADYX TE4433H / GENIUS ECHO TX4 Remote Controls This document provides programming instructions for the ADYX TE4433H and GENIUS ECHO TX4 remote controls operating at 433 MHz. Learn how to memorize your remote control to the receiver module.
	Formulaire de retour de produit usagé - ALLO Télécommande Formulaire pour le retour de produits usagés d'Allotélécommande. Ce document permet aux clients de retourner des produits pour recyclage dans le cadre d'une démarche de développement durable.
	REMOCON RMC 168 SL Programming Instructions Step-by-step guide for programming the REMOCON RMC 168 SL remote control using an already programmed remote.

Programming from an existing remote control:

Related Documents