Programming Notice
Coding a Remote Control with Mini-Switches (DIP-Switch)
Diagram of Switches
The following diagrams illustrate the ON and OFF positions for the mini-switches (DIP-switches) numbered 1 through 10.
Switches 1-5:
ON: [Black bar at the top] OFF: [Black bar at the bottom]
Switch 1: ON Switch 2: OFF Switch 3: ON Switch 4: OFF Switch 5: ON
Switches 6-10:
ON: [Black bar at the top] OFF: [Black bar at the bottom]
Switch 6: ON Switch 7: OFF Switch 8: ON Switch 9: OFF Switch 10: ON
How to Code a Remote Control with Mini-Switches
- First, open a remote control already in service on the installation, then refer to switch 7.
- Next, open your new remote control and position the mini-switches of the new remote control in the same position.
- Finally, close the remote controls and test them.
