Notice de programmation
ADYX TE4433H / GENIUS ECHO TX4
This notice explains how to program your remote control to a 433 MHz receiver module.
Image Description: The image displays three items side-by-side. On the left is a blue ADYX remote control with four buttons. An arrow points from this remote to a black remote control with four circular buttons labeled 'GENIUS'. To the right of the black remote is a close-up view of a green circuit board with various electronic components, including capacitors and chips.
How to memorize this remote control at 433 MHz
- Use 433 MHz remote controls with the 433 MHz receiver module.
- Press the LOGIC (SW3) or SPEED (SW2) button (colored red in the photo) to memorize the total opening (open A) or partial opening (open B) respectively, while keeping it pressed.
- Also press the SETUP (SW1) button (colored red in the photo).
- The corresponding LED will start to blink slowly for 5 seconds.
- Release both buttons. During these 5 seconds, press the desired button on the remote control.
- The LED will light up steadily for 1 second, indicating that the memorization has been completed, then it will start blinking again for an additional 5 seconds during which another remote control can be memorized.
- After 5 seconds, the LED will turn off, indicating the end of the procedure.
- To add other remote controls, repeat the operation starting from step 1.
Thank you for choosing AlloTelecommande.
