Aprilaire Ventilating Dehumidifier
Models E100V + 8190FF | Specification Sheet
Specifications
| Nominal ventilation airflow (CFM) | 150 CFM |
| Capacity(1) pints/day | 100 ppd |
| Energy factor(1) | 2.6 L/kW-h (5.5 pints/kW-h) |
| Airflow @ varying E.S.P. (external static pressure - dry coil) | |
| 0.0" w.c. | 280 CFM |
| 0.2" w.c. | 245 CFM |
| 0.4" w.c. | 210 CFM |
| Voltage, phase, frequency | 120VAC, 1 phase, 60 Hz |
| Current draw(1) | 6.9 Amps |
| Noise-Fan Only | 52.8 dBA (ducted) |
| Noise-Compressor and Fan | 55.0 dBA (ducted) |
| Dimensions: (combined cabinets)(2) | Width: 14½" Height: 23½" w/o adjustable feet Length: 48¼" |
| Weight | |
| -E100V Unit Weight: | 64 lbs. |
| -E100V Shipping Weight: | 82 lbs. |
| -8190FF Unit Weight: | 13.7 lbs. |
| -8190FF Shipping Weight: | 16.8 lbs. |
| Inlet air operating conditions during | |
| -Dehumidification: | 50°F–104°F, 40°F dew point min. |
| -Ventilation: | 40°F–140°F, 0%–99% RH |
(1) Rated capacity, energy factor and current draw measured at 80°F/60% RH inlet air at 0.0 ESP.
(2) Height does not include adjustable feet. Length includes the duct collars, and width includes the filter doors.
(3) Thread adapter and barbed fitting for clear drain tubing included.
Models
- Model E100V - Dehumidifier (requires 8190FF)
- Model 8190FF - Ventilation Plenum for Aprilaire Dehumidifier
Features
- E100V Dehumidifier is wired specifically for use with the 8190FF Ventilation Plenum
- Patent-pending ventilation design
- Removes moisture from outdoor air before it enters the living space
- Unit is designed, when properly installed, to achieve ASHRAE Standard 62.2
- Integral moisture and ventilation control
- Optional ventilation control via thermostat (see below)
- High and low temperature limit lock-outs
- Simple plug-in installation
- Installation temperature range up to 140°F
Unit Features
| Control | Built-in digital control with display |
| Cabinet insulation | 1/2" EPS |
| Air discharge orientation | Top |
| Inlet/Outlet duct collars | 10" round |
| Backflow damper at outlet | Included |
| Air filter | Washable MERV 8 |
| Refrigeration | R-410A |
| Coil type | Corrosion-resistant aluminum |
| 8' Power cord type | Plug type |
| Drain connection(3) | 3/4" PVC adapters |
| Warranty | 5 Years |
Recommended Controls
Aprilaire Thermostat Models
- 8620, 8620W
- 8910, 8910W
- 8920W
Aprilaire Communicating Thermostat Models
- 8820
- 8830
- 8840
Zone Control Systems
- 6010
- 6015
- 6020
- 6025
- 6030
- 6035
- 6040
- 6045
Benefits
- Helps control RH in the home during periods when the air conditioning system does not run long enough to remove sufficient moisture. If air conditioner can satisfy RH requirements, the Aprilaire unit's compressor shuts off.
- Optimize energy savings by locking out ventilation during hottest/coldest times of the day.
- Improves indoor air quality.
- Installation labor reduced, requires only a power outlet and 24 volt wiring to HVAC system.
Compliance with Ventilation Standards
When properly installed and set, the Aprilaire Ventilating Dehumidifier will meet the mechanical ventilation requirements of:
- ASHRAE 62.2
- Energy Star Certified Homes
- EPA Indoor airPLUS
- International Residential Code (IRC)
Installation Guidance
Product Overview: The Aprilaire E100V Ventilating Dehumidifier, shown with the 8190FF Ventilation Plenum, is a compact unit designed for whole-house humidity control and ventilation. It features an ENERGY STAR "Most Efficient 2021" designation.
Dimensions: The combined unit dimensions are approximately 14.5 inches in width, 23.5 inches in height, and 48.25 inches in length, including duct collars. The ventilation plenum adds to the overall depth.
Control Panel: The unit features a digital display with controls including an ON/OFF button to manage the ventilator, a MODE button to access ventilation time settings, and UP/DOWN buttons to adjust humidity or vent time.
Ducting the Ventilating Dehumidifier
Attic Installation
This diagram illustrates an attic installation. The Aprilaire Ventilating Dehumidifier (Dehum W/Ventilator) is connected to the HVAC system via a return mixing box. Fresh air is drawn from outside through a fresh air intake duct connected to an intake hood with a screen, typically mounted on a gable end wall, band joist, or porch soffit. Airflow is shown entering the unit and then being distributed.
Basement Installation
This diagram shows a basement installation. Fresh air is pulled from outside through a duct and intake hood, then mixed with return air from the HVAC system before entering the main unit. The unit is connected to the HVAC system, with a minimum of 6 feet of ducting for the fresh air intake.
Contact and Warranty Information
Contact Information:
P.O. Box 1467
Madison, WI 53701-1467
Phone: 800.334.6011
Fax: 608.257.4357
Website: AprilairePartners.com
Form No. 3065 307140 2.21
©2021 Aprilaire - Division of Research Products Corporation
Warranty: 5 Years Warranty.
Manufacturing: Made in the USA.
Note: Aprilaire reserves the right to change specifications without notice.
