AprilAire E100V/8190FF Ventilating Dehumidifier
Specification Sheet
Features
- E100V Dehumidifier is wired specifically for use with the 8190FF Ventilation Plenum.
- Patent-pending ventilation design.
- Removes moisture from outdoor air before it enters the living space.
- Unit is designed, when properly installed, to achieve ASHRAE Standard 62.2.
- Integral moisture and ventilation control.
- High and low temperature limit lock-outs.
- Simple plug-in installation.
- Installation temperature range up to 140°F.
- Optional dehumidification control via thermostats.
Product Overview
The AprilAire E100V Ventilating Dehumidifier is shown paired with the 8190FF Ventilation Plenum. The combined unit is grey. A 5-year warranty badge and USA assembly information are visible.
Specifications
| Specification | Value |
|---|---|
| Nominal ventilation airflow (CFM) | 150 CFM |
| Capacity(1) pints/day | 100 ppd |
| Energy factor(1) | 2.6 L/kW-h (5.5 pints/kW-h) |
| Airflow @ varying E.S.P. (external static pressure - dry coil) |
|
| Voltage, phase, frequency | 120VAC, 1 phase, 60 Hz |
| Current draw(1) | 6.9 Amps |
| Noise-Fan Only | 52.8 dBA (ducted) |
| Noise-Compressor and Fan | 55.0 dBA (ducted) |
| Dimensions (combined cabinets)(2) |
|
| Weights |
|
| Inlet air operating conditions during |
|
| Control | Built-in digital control with display |
| Cabinet Solution | 1/2" EPS |
| Air discharge orientation | Top |
| Inlet/Outlet duct collars | 10" round |
| Backflow damper at outlet | Included |
| Air filter | Washable MERV 8 |
| Refrigeration | R-410A |
| Coil type | Corrosion-resistant aluminum |
| 8' Power cord type | Plug type |
| Drain connection(3) | 3/4" PVC adapters |
| Warranty | 5 Years |
Dimensional Drawings
Dimensional drawings indicate the unit's width is 14 1/2 inches, length is 48 1/4 inches, and height (without adjustable feet) is 23 1/2 inches. The ventilation plenum has a height of 12 5/16 inches and a width of 17 1/4 inches.
Control Panel
The integrated digital control panel features an ON/OFF button to control the ventilator, a MODE button to access ventilation time settings, and UP/DOWN buttons to adjust humidity or vent time. The display shows the current status, such as '5' and 'ON'.
Ducting the Ventilating Dehumidifier
Attic Installation
The attic installation diagram illustrates a fresh air intake hood with a screen (model 90-2065) mounted on an exterior wall. A fresh air intake duct connects this to the AprilAire Dehumidifier with Ventilator. The unit then connects to a filter, a return mixing box, and finally the furnace or air handler, showing the airflow path.
Basement Installation
The basement installation diagram shows fresh air being drawn from outside through an intake hood and ducted to the AprilAire unit. The unit's output is connected to the HVAC/Furnace system. A minimum 6-foot duct length is recommended for the connection.
Benefits
- Helps control relative humidity (RH) in the home during periods when the air conditioning system does not run long enough to remove sufficient moisture. If the air conditioner satisfies RH requirements, the AprilAire unit's compressor shuts off.
- Optimizes energy savings by locking out ventilation during the hottest/coldest times of the day.
- Improves indoor air quality.
- Installation labor is reduced, requiring only a power outlet and 24-volt wiring to the HVAC system.
Compliance
When properly installed and set, the AprilAire Ventilating Dehumidifier will meet the mechanical ventilation requirements of:
- ASHRAE 62.2
- Energy Star Certified Homes
- EPA Indoor airPLUS
- International Residential Code (IRC)
Recommended Controls
AprilAire Thermostat Models
- 8620
- 8620W
- 8910
- 8910W
- 8920W
AprilAire Communicating Thermostat Models
- 8820
- 8830
- 8840
Zone Control Systems
- 6010
- 6015
- 6020
- 6025
- 6030
- 6035
- 6040
- 6045
