Resistex Argos déco Installation Guide

Safety and Maintenance Instructions

Safety Notes

• ⚠️ Never work when voltage is present on the luminaire.
• The installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• Risk of electrostatic discharges (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasive products to clean the fixture.
• Keep these instructions for dismantling or future maintenance. You can consult additional information about RESISTEX luminaires on the website www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Installation Instructions

This section details the installation process for the Resistex Argos déco lighting fixture, covering two mounting options: Ceiling Mount (KIT PLAFONNIER) and Suspension Mount (KIT SUSPENSION).

KIT PLAFONNIER (Ceiling Mount Kit)

1. Step 1: Mount the bracket.

   Install the mounting bracket onto the ceiling. Use the provided screws (x2) and wall plugs (x2). Ensure a spacing of 106mm between mounting points.

   Diagram shows a rectangular mounting bracket, two screws, two wall plugs, and a measurement indicating 106mm spacing.

2. Step 2: Attach the luminaire body.

   Connect the luminaire body to the previously mounted bracket.

   Diagram shows the main luminaire body being attached to the mounted bracket.

3. Step 3: Connect electrical wires.

   Make the electrical connections inside the luminaire. Connect the Neutral wire (N), Earth wire (E), and Live wire (L) to the corresponding terminals.

   Diagram shows a terminal block with three clearly labeled positions: N (Neutral), E (Earth), and L (Live).

4. Step 4: Secure the luminaire.

   Ensure the luminaire is securely fastened and all connections are properly made.

   Diagram shows the fully installed luminaire attached to the ceiling.

KIT SUSPENSION (Suspension Mount Kit)

1. Step 1: Install ceiling anchors.

   Install the ceiling anchors for the suspension cables. Ensure a spacing of 106mm between the anchor points.

   Diagram shows two ceiling anchors, two suspension cables, and a measurement indicating 106mm spacing.

2. Step 2: Attach luminaire to suspension cables.

   Connect the luminaire body to the suspension cables.

   Diagram shows the main luminaire body being connected to the suspension cables.

3. Step 3: Connect electrical wires.

   Make the electrical connections inside the luminaire. Connect the Neutral wire (N), Earth wire (E), and Live wire (L) to the corresponding terminals.

   Diagram shows a terminal block with three clearly labeled positions: N (Neutral), E (Earth), and L (Live).

4. Step 4: Secure the luminaire.

   Ensure the luminaire is securely fastened and all connections are properly made.

   Diagram shows the fully installed luminaire suspended from the ceiling.