VILTO Shelving Unit
by IKEA
Safety Warnings
WARNING: Children have died from furniture tipover. To reduce the risk of furniture tipover:
- ALWAYS install the anti-tip device provided.
- NEVER put a TV on this product.
- NEVER allow children to stand, climb, or hang on any drawers, doors, or shelves.
- NEVER open more than one drawer at a time.
- Place heaviest items in the lowest drawers.
This warning is provided in multiple languages within the original document to ensure understanding across different regions.
Parts List
The following parts and hardware are included for assembly:
- Wooden Dowels (101350): 8x
- Screws (157436): 12x
- Bolts/Adjustable Feet (157732): 4x
- Metal Assembly Bar (121030): 1x
- Allen Key (100092): 1x
- Bracket (157084): 1x
- Screw for Bracket (157433): 1x
- Washer for Bracket (157424): 1x
Assembly Steps
Step 1
Lay out the main frame components. Attach the two side panels to the base structure using twelve screws (157436) and the Allen key (100092) with the metal assembly bar (121030). Ensure the correct orientation as shown in the diagram.
Step 2
Attach the second side panel to the frame using screws (157436) and the Allen key (100092) with the metal assembly bar (121030).
Step 3
Attach the third side panel to the frame using screws (157436) and the Allen key (100092) with the metal assembly bar (121030).
Step 4
Insert eight wooden dowels (101350) into the pre-drilled holes on the shelf panels.
Step 5
Slide the shelf panels into the corresponding slots on the assembled frame.
Step 6
Secure the shelf panels by inserting dowels from the outside of the frame into the shelf panels.
Step 7
Connect the remaining frame components using screws (157436) and the Allen key (100092) with the metal assembly bar (121030).
Step 8
Attach the four adjustable feet (157732) to the bottom of the shelving unit using the provided bolts/screws.
Step 9
Stand the shelving unit upright. Adjust the feet (157732) by screwing them in or out to level the unit on uneven floors. Use a spirit level [spirit level tool] for best results.
Step 10: Wall Anchoring (Anti-Tip Device)
IMPORTANT SAFETY STEP: To prevent tipover, the unit MUST be secured to the wall using the provided anti-tip hardware. ⚠️
Attach the bracket (157084) to the top rear of the shelving unit using one screw (157433) and one washer (157424).
Mark the desired location on the wall. Secure the bracket to the wall using appropriate wall fixings (not included, choose based on your wall type).
Ensure the unit is stable and securely anchored.
