SPD 3100 Pet Water Fountain
Quick Start Guide
Safety Notice
WARNING: Failure to follow these safety notices could result in fire, electric shock or other injuries. Read all the safety notices below before use.
- Avoid high humidity or extreme temperatures.
- Avoid long exposure to direct sunlight or strong ultraviolet light.
- Do not drop or expose the unit to intense vibration.
- Do not disassemble or try to repair the unit yourself.
- Do not expose the unit or its accessories to flammable liquids, gases or other explosives.
- Ensure that the water level in the water tank is not lower than the minimum water level and not higher than the maximum water level.
- Please replace the filter once a month to ensure the filtration effect.
- If the pump becomes noisy after a period of time use, please remove the pump and clean it.
Technical Specifications
| Hopper Capacity | 1.4 L |
| Power | DC 5V 1A USB |
| Material | ABS Plastic |
| Dimension | 163x164x160 mm |
| N. W. | 0.5KG |
1 In the Box
- Pet Water Fountain x 1
- Filter Cotton x 1
- USB cable x 1
- Quick Guide x 1
Please check the condition and the accessories of the water fountain after you open the box.
2 Get to know your device
The pet water fountain consists of the following parts:
- Flower: The water spout.
- Head Cover: The uppermost cover.
- Top Cover: Covers the filter and pump mechanism.
- Pump: Circulates the water.
- Pipe: Connects the pump to the Flower.
- Filter: Filters the water.
- Water Tank: Holds the water.
LED Indicator
| Light | Status |
|---|---|
| Blue light is always on | Normal |
| Red light flashes | Water shortage alarm |
| Red light is always on | Stopped |
3 Get Started
-
Step 1: Fix pipe on pump
Attach one end of the pipe to the pump. [Diagram shows pipe connecting to pump]
-
Step 2: Fix pipe to top cover
Attach the other end of the pipe to the lower end of the top cover. [Diagram shows pipe connecting to top cover]
-
Step 3: Route USB cable
Thread the USB cable through the built-in cable hole in the water tank. [Diagram shows cable routing]
-
Step 4: Water level
Ensure the water level is between the minimum (MIN) and maximum (MAX) water level markers inside the tank. [Diagram shows MIN/MAX markers]
-
Step 5: Fix top cover
Secure the top cover onto the water tank. [Diagram shows top cover placement]
-
Step 6: Place filter
Insert the filter into the slot in the top cover. Important: Wet the filter before using it. [Diagram shows filter placement]
-
Step 7: Tighten cover
Rotate the cover clockwise to tighten it. [Diagram shows clockwise rotation]
-
Step 8: Install flower and power
Attach the flower spout and connect the USB cable to a power source. [Diagram shows flower and power connection]
