GZDW-V1 Storage Cabinet Assembly Instructions

Notice

1. Please unbox the item from the side with an open label and put a carpet on the floor to avoid scratching parts.
2. Follow the installation instructions carefully. Before installation, please ensure that all accessories are present. For large items, we advise you to install them with 2 or more people for faster and safer installation.
3. Do not fully tighten the screws during initial assembly. Fully tighten the screws only once all pieces are correctly assembled. Do not use power tools.
4. Do not stand, climb, or swing on the product.
5. If you encounter any problems during installation, please contact customer service.

Parts List

The following parts are included in the package:

• 1: Base Panel (1 PC)
• 2: Side Panel (1 PC)
• 3: Side Panel (1 PC)
• 4: Back Panel (1 PC)
• 5: Top Panel (1 PC)
• 6: Shelf Panel (1 PC)
• 7: Top Surface (1 PC)
• 8: Support Bar (1 PC)
• 9: Support Bar (1 PC)
• 10: Frame (2 PCS)
• 11: Support Rod (1 PC)
• 12: U-shaped Bracket (3 PCS)
• A: Screw M6*10 (6 PCS)
• B: Screw M5*40 (14 PCS)
• C: Screw M6*28 (14 PCS)
• D: Screw M6*40 (5 PCS)
• E: Screw M5*50 (2 PCS)
• F: Screw M8*10 (8 PCS)
• G: Screw M8*10 (8 PCS)
• H: Screw M8*10 (2 PCS)
• I: Screw M8*10 (2 PCS)
• J: Screw M8*10 (1 PC)
• K: Screw M8*10 (2 PCS)
• L: Screw M3.5*12 (6 PCS)

Assembly Steps

STEP 1

Attach three U-shaped brackets (12) to the base panel (1) using six screws (A).

STEP 2

Attach side panels (2) and (3) to the base panel (1). Ensure the orientation of the holes is correct. Use screws (B) and (C) as indicated.

STEP 3

Attach the back panel (4) to the assembled structure using screws (D).

STEP 4

Attach the shelf panel (5) to the side panels using screws (B) and (C).

STEP 5

Insert the support rod (11) into the designated holes on the side panels.

STEP 6

Attach the shelf panel (6) to the side panels using screws (B) and (C).

STEP 7

Attach the frames (10) to the sides of the cabinet. Use screws (F), (G), (J), and (K) as shown.

STEP 8

Attach the support bars (8) and (9) to the frames using screws (D).

STEP 9

Slide the top surface (7) into place, securing it with screws (D) and (L). Remember to remove the plastic film from the remote control area before use.

STEP 10

Attach the remaining components using screws (B), (C), and (E) as illustrated.

STEP 11

Secure the final parts using screws (H) and (I).

STEP 12

Installation Completed.