Hamron 609208 Bike Carrier

Safety Instructions

Read the instructions carefully before use and save them for future reference.

WARNING!

• Check that the axle load for the vehicle is not exceeded with bikes loaded on the carrier. The weight of the bike carrier is 16.5 kg.
• Check that the permitted load on the towbar is not exceeded.
• The towbar must as a minimum be of the ST 52-3 or GGG 52 type, with a permitted load of at least 60 kg. No more than 4 bikes can be loaded on the carrier.
• The mounted bike carrier conceals the number plate on the vehicle and therefore a separate number plate must be fitted on the bike carrier.
• Never drive over the speed limit. The maximum speed with bikes loaded on the bike carrier is 120 km/h.
• Always check that the opening mechanism is closed and secured before driving.
• Before fitting the bike carrier, switch off the ignition on the vehicle, remove the ignition key and apply the parking brake.
• Avoid sharp braking and acceleration.
• Avoid sharp turns. Do not turn at speeds over 40 km/h.
• Do not drive at speeds over 40 km/h in heavy traffic.
• After fitting the bike carrier, drive a short distance to check all the screw unions and other connections. Adjust and tighten if necessary. Check all connections at regular intervals. Check more often in demanding conditions.
• The bike carrier increases the width and length of the vehicle when loaded with bikes.
• Be careful when reversing.

Symbols

Read the instructions. ?

Technical Data

Mounting

Refer to figures 1-8 for mounting instructions.

Mounting of bikes on the platform

Place the bike in the tyre carriers. Fasten the grip on the bike frame (figure 3). The bikes must be turned opposite each other. Fasten the wheel straps (figure 1-2).

Opening the boot

Hold the bike platform with one hand, and pull the tilt handle with the other hand. Tilt down the bike platform until it is in the bottom position or resting on the ground. The boot can now be opened. Remember to tilt back the platform again before driving (figure 8).

Maintenance

• Clean the product with a damp cloth after use.
• Apply a suitable oil on all screw unions, and store the bike carrier in a dry place.

WARNING!

• Remove the bike carrier before washing the car.
• Do not use solvent or caustic solutions.

Manufacturer and Distributor Information

Manufacturer: Jula AB, Box 363, 532 24 SKARA

Distributor: Jula Poland Sp. z o.o., ul. Malborska 49, 03-286 Warszawa, Polska

Distributor: Jula Norge AS, Solheimsveien 30, 1473 LØRENSKOG

For the latest version of the operating instructions, visit www.jula.com.