SHINING 3D AccuFab L4D 3D Printer

Unpacking

1. Open the package and take out the "product certificate", "installation guide", and power cable ➀.
2. Remove foam ➁, take out the spare resin tank ➂ from the back of the printer.
3. Remove the package, place the printer on the table, and open the printer chamber door. Remove fixing foam ➃ & ➄ inside the printer.
4. Take out accessory box ➅ from fixing foam ➄.
5. Connect the power supply ➆ and press the power button on the right side of the printer. During printer initialization, the platform will go to the top position.
6. Wait for the printer stop moving, open the buckles ➈ and take out the resin tank ➉. Remove the protect film around the resin tank.
7. Put clean resin tank ➉ into the position. Lock the buckles ➈ for the resin tank. (There are four positioning slots)
8. As the following picture shows, installation is completed.

Add Material

Shake for 2 mins before pouring material into the resin tank to avoid sediment. Note that the resin level should be between the indicator lines of minimum and maximum.

Note: You can also add resin during printing without pausing.

First Print

Please refer to the "AccuFab-L4D Quick Start Guide" in the flash drive. The flash drive can be used for data transmission later on.

Product Preview

Key Components:

• Build platform bracket
• Build platform
• Resin tank
• Touch screen
• Chamber door
• B-type USB port
• Network port
• Power button
• Power port

Part List

• Spare Resin tank
• Power Cable
• Network cable
• Quality Certification
• Installation Guide
• Disposable Gloves
• Flash Drive: Contains Installer of AccuWare, Printer profile "*.sndev", User Manual, Quick Start Guide and "Factory test reports".
• Angular Knife: Used to remove models from the platform after printing finished.
• Putty Knife: Used to remove models from the platform after printing finished.
• Brush: Used to clean extra resin on the model.
• Scraper: Used to stir resin in the tank to avoid sediment.
• Wrench
• Cleaning Box: Used to store parts or alcohol.
• Bolt
• Resin tank cleaner
• Cloth: Used to clean optical path including projector lens, protection glass and resin tank glass.
• PET Card: Used to level the platform and remove the cured layer.

Support and Resources

Document Download Center: https://www.shining3d.com/download-center/

Support Center: https://support.shining3ddental.com/en/support/solution

Aftersales service: Create support ticket • Check ticket status

Technical resource: FAQS • Basic Tutorials • Useful tips • Webinars

Contact Information

APAC HEADQUARTERS
SHINING 3D Tech.Co., Ltd.
P: +86-571-82999050
No.1398 Xiangbin Road, Wenyan, Xiaoshan,
Hangzhou, China, 311258

AMERICAS REGION
SHINING 3D Technology Inc.
P: +1415 259 4787
1740 César Chávez St. Unit D. San Francisco,
CA 94124, United States

EMEA REGION
SHINING 3D Technology GmbH
P: +49-711 28444089
Breitwiesenstraße 28, 70565
Stuttgart, Germany