Scosche HY1603 In-Dash Installation Kit

Assembling the Kit: ISO DIN Mount

Instructions for ISO DIN Mount (DIN-E Radio with Side Mounting Holes):

1. Snap the ISO DIN side mounting brackets (1 left and 1 right) to the back of the mounting panel. Use supplied hardware to bolt them to the back of the kit panel.
2. Load the radio from the REAR of the mounting panel until the nosepiece of the radio comes through the front of the kit.
3. Use the 5mm screws to secure the radio from the sides.

CAUTION: Rear supporting the radio adds to the installation's structural integrity.

Components shown: 5333 Mounting Panel, ISO DIN Radio, 5057 Left Bracket, 5057 Right Bracket, 5mm Screws. Various Rear Supports (Not Included).

2002-05 Hyundai Accent Radio Removal

1. Open cup holder and extract (2) Phillips head screws from behind.
2. Open glovebox and release stoppers so that glove box is hanging down. Release (1) cable from behind.
3. From above the gas pedal, release (2) cables.
4. Carefully unsnap the perimeter of the dash bezel and slowly remove the dash bezel. Disconnect and remove.

Introduction

This premium installation kit is for 2002 Hyundai Accent vehicles. It includes all the parts needed to mount your car stereo/cassette or CD player into your vehicle's dash. Refer to the individual instruction in this manual to remove your vehicle's factory radio and assemble the kit.

CAUTION: Disconnect your vehicle's negative battery terminal before installation to help prevent electrical damage. It is recommended to use a volt/ohm meter over a test light to check wiring, as a test light or grounded wire probe can cause damage to the vehicle's computer and/or diagnostic systems. Avoid all factory airbag wiring, as airbags can accidentally deploy, causing serious injury or death.

NOTES:

• See your vehicle's instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting instructions.

Car Stereo Connectors

Provide easy connection of your car stereo to factory wiring harness.

Connector Type: HY03 2000-UP Hyundai.

Liability Disclaimer

This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/codes, and information pertaining to the installation of this kit (#HY1603) in 2002 Hyundai Accent Vehicles. Scosche Industries, Inc. cannot be held responsible for discrepancies or inconsistencies that may occur due to the automobile during the installation of components while using this booklet.