Cycplus M1 Cycling Computer

Introduction

Name: Cycling Computer

Model: M1

Screen Size: 2.9-inch LCD

Product Size: 90*53*20 mm

Weight: 77.5 g

Battery: 1200 mAh 3.7V

Memory Capacity: 150 hours

Working Time: 30-35 hours

Charging Mode: Type-C

Charging Time: Approximately 3.5 hours

Connectivity: Bluetooth 5.0

Peripheral Connection: ANT+

Supported Devices: Speed sensor, Cadence sensor, Heart rate sensor, Power meter.

Water Resistance: IPX6 (rainproof, not submersible)

GPS Location - Operating Instructions

For satellite signal reception, ensure the device is used in an open area without obstructions.

1. Press the [left button] to turn on.
2. GPS signal acquisition takes a few minutes after startup. The icon indicates the device is ready.
3. Press the [left button ►II] again to start recording. The symbol ► will appear after recording starts.
4. Press and hold the [middle button] to save recorded data. The symbol ► will disappear after data is saved.
5. Press and hold the [left button] to turn off.

Current Data Display

The device displays various real-time data including time, speed, heart rate, cadence, power, distance, altitude, and gradient.

Display Modes:

• AVG: Average data
• MAX: Maximum data

The screen can be navigated to show different data sets by pressing the right button to switch pages.

Settings

Press and hold the [right button] to enter settings. Press the [right button] to switch between 8 settings.

Connecting ANT+ Sensors

Press the left button to start searching for ANT sensors. After 10 seconds, the device will return to the main screen. The device will display data once connected. To disconnect sensors, navigate to the C9 screen and press the left button to disconnect all paired sensors.

Setting the Wheel

Use the left button to start setting. Use the right button to adjust the character. Use the middle button to switch the character to be adjusted. Press the left button to exit settings.

Time Zone Setting

Press the left button to start setting. Use the right button to change the time zone. Use the middle button to switch the time zone digit. Press the left button to exit settings.

Speed Unit Setting

Press the left button to start setting. Use the right button to switch between KMH and MPH.

Temperature Unit Setting

Press the left button to start setting. Use the right button to switch between °C and °F.

Customizing Factory Settings

Press the left button to start setting. Pressing and holding the middle button will restore factory settings and turn off the device.

Odometer Setting

Press the left button to start setting. Use the right button to adjust the number. Use the middle button to switch the number to be adjusted. Press the left button to finish editing.

Connecting to XOSS App

Scan the QR code or download the app from Google Play or the App Store. Register with your email and turn on Bluetooth.

Connecting to M1

Open "XOSS", select CYCPLUS M1, and then click to connect.

Connecting to Strava / Training Peaks

Find Strava / Training Peaks in your personal files and click "Connect". Log in to your Strava / Training Peaks account using your username and password. Note: Google and Facebook account logins are not supported.

Data Update and Analysis Check

Click "Synchronize" to sync the record with the app. If Strava is connected, data will automatically sync to Strava. Select an activity on the exercise page to view cycling data.

Important Notes

• Data Recording: Press and hold the left button to turn on the device, and press the left button to start recording data. Remember to press and hold the middle button to save data after finishing your ride.
• Memory: When the memory is full, the computer will overwrite previous records chronologically.
• Backlight: After setting the time zone, the backlight will automatically turn on every night between 18:00 and 9:00. The display will light up when any button is pressed and turn off after 10 seconds.

Package Contents

• GPS Cycling Computer
• Mount for computer
• Rubber gasket
• User Manual
• Gummyx 3
• Type-C charging cable

Installation Information

1. CYCPLUS Z1/Z2: Mount the computer on the bike (must be purchased separately).
2. Use the computer mount. Secure the mount with the rubber gasket.

Manufacturer Information

Chengdu Chendian Intelligent Technology Co., Ltd.

Tire Circumference Chart

Please use this table for informational purposes only. Tire circumference may vary depending on tire pressure.

EU Declaration of Conformity

Chengdu Chendian Intelligent Technology Co., Ltd. hereby declares that the radio equipment type [Cycplus M1 Cycling Computer] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://files.innpro.pl/Cycplus

Manufacturer Address: Unit 2, Building 2, No. 88, Tianchen Road, Chengdu, Sichuan, CN, Postal Code: 611730

Radio Frequency Range: 2400MHz-2483.5MHz

Maximum Radio Frequency Power: 0 dBm

Environmental Protection

Electronic waste marked in accordance with the EU directive must not be disposed of with other municipal waste. It is subject to separate collection and recycling at designated sites. By ensuring its proper disposal, you will prevent potential negative consequences for the environment and human health. The system for collecting used equipment is in accordance with local environmental protection regulations for waste disposal. Detailed information on this topic can be obtained from the municipal office, the processing plant, or the store where the product was purchased. The product complies with the requirements of the so-called new approach directives of the European Union (EU) in the field of safety, health, and the environment, which specify hazards that should be identified and eliminated.

This document is a translation of the original user manual issued by the manufacturer.

The product must be regularly maintained (cleaned) by the user or a specialized service center at the user's expense. If the user manual does not provide information on necessary cyclical maintenance or service operations, it is necessary to regularly, at least once a week, evaluate the deviation of the physical condition of the product from a physically new product. If any deviation is found or detected, maintenance (cleaning) or service measures must be taken immediately. Failure to perform proper maintenance (cleaning) and failure to respond to the detected deviation may result in permanent damage to the product. The guarantor is not responsible for damages resulting from negligence.

Importer: INNPRO Robert Błędowski sp. z o.o. Rudzka 65c 44-200 Rybnik, Poland Tel: +48 533 234 303 hurt@innpro.pl www.innpro.pl

For LI-ION Batteries

The device is equipped with a LI ION (lithium-ion) battery, which ages over time and with use due to its financial and chemical structure. The manufacturer indicates the maximum operating time of the device under laboratory conditions, where optimal operating conditions exist for the device and the battery itself is new and fully charged. The operating time may actually differ from the time declared in the offer and is not a defect of the device, but a characteristic of the product. To maintain maximum battery life, it is not recommended to discharge the battery below 3.18 V or 15% of its total capacity. Lower values, such as 2.5 V per cell, will permanently damage it and are not covered by warranty. If you do not use the battery or the entire device for more than one month, charge the battery to 50% and check its charge level every two months. Store the battery and device in a dry place, away from sunlight and negative temperatures.

For LIPO Batteries

The device is equipped with a LI PO (lithium-polymer) battery, which ages over time and with use due to its final and chemical structure. The manufacturer indicates the maximum operating time of the device under laboratory conditions, where optimal operating conditions exist for the device and the battery itself is new and fully charged. The operating time may actually differ from the time declared in the offer and is not a defect of the device, but a characteristic of the product. To maintain maximum battery life, it is not recommended to discharge the battery below 3.5 V or 5% of its total capacity. Lower values, such as 3.2 V per cell, will permanently damage it and are not covered by warranty. If you do not use the battery or the entire device for more than one month, charge the battery to 50% and check its charge level every two months. Store the battery and device in a dry place, away from sunlight and negative temperatures.

Safety Precautions

• Before charging, check that the device contacts are clean.
• Do not leave the device unattended during use and charging.
• Ensure that you can quickly disconnect the device from the power source in case of emergency.
• Never expose the device to high temperatures.
• Charge the device in a dry and well-ventilated place, away from the surroundings. Maintain a minimum distance of 1 m from other objects.
• Never cover the device while charging.
• Never use power adapters, charging stations, cables, etc., without the manufacturer's recommendation and approval.
• Take care of your property; the device is equipped with cells that are difficult to extinguish; have a fire extinguisher ready.

Warranty

The warranty is void in case of changes and/or modifications to the product. The manufacturer is not responsible for damages caused by improper use of this product.

Disposal

• Dispose of this product at a designated collection point.
• Do not dispose of this product with municipal waste.
• For more information, contact the seller or local authorities responsible for waste management.

Documentation

This product was manufactured and is supplied in accordance with all applicable regulations and directives valid in all member states of the European Union. It also meets all relevant specifications and regulations in the country of sale. Official documentation can be obtained upon request. Official documentation includes (but is not limited to) Declaration of Conformity, Material Safety Data Sheets, and product test reports.

Disclaimer

The design and specifications of the product may be changed without prior notice. All logos and trade names are registered trademarks of their respective owners and are protected by law.