LÖNSET Slatted Bed Base Assembly Instructions

Product Overview

This document provides step-by-step instructions for assembling the IKEA LÖNSET slatted bed base. The LÖNSET is designed to provide support and ventilation for mattresses.

Parts Included

• Hex Key (Part ID: 100006): 1x
• Screws (Part ID: 100229): 12x
• Screws (Part ID: 109049): 2x
• Washers (Part ID: 100823): 2x
• Wooden Slats: 10x
• Longer Wooden Supports/Rails: 18x
• Plastic Connectors/End Caps: 3x
• Central Support Rails: 2x
• Fabric Strap (Part ID: 139221): 1x

Note: Assembly may require a screwdriver. A diagram indicates that a specific screwdriver is not provided or not the correct tool for all steps.

Assembly Steps

Step 1: Attach Side Rails to End Pieces

Begin by attaching the side rails to the end pieces of the bed frame. Use the hex key (100006) and screws (100229). This connection is made three times (3x).

Diagram Description: Shows the hex key and screws being used to connect a side rail to an end piece. A magnified view details the connection point.

Step 2: Continue Frame Assembly

Continue attaching the remaining side rails to the end pieces using the hex key and screws (100229). A magnified view shows correct screw insertion. A crossed-out diagram indicates an incorrect method of screw insertion.

Diagram Description: Shows the main frame structure taking shape. Magnified views illustrate screw insertion and highlight incorrect methods.

Step 3: Insert Wooden Slats

Thread the fabric strap (139221) through the designated slots on the frame. Insert the wooden slats (10x) into the plastic connectors attached to the frame. Arrows indicate the correct direction for insertion. A crossed-out diagram shows incorrect slat insertion.

Diagram Description: Shows the main frame with the fabric strap being positioned. Magnified views demonstrate how to slide the wooden slats into the plastic holders, with directional arrows.

Step 4: Complete Slat Insertion

Continue inserting the remaining wooden slats into the connectors along the frame.

Diagram Description: Shows the frame with most of the wooden slats now in place. Magnified views continue to illustrate correct and incorrect slat insertion methods.

Step 5: Position Central Support Rails

Place the two central support rails onto the frame. These rails run lengthwise and provide additional support.

Diagram Description: Shows the central support rails being laid across the assembled frame.

Step 6: Secure Central Support

Secure the central support rails using the hex key (100006) and screws. Three (3x) connections are made for this purpose. The diagram also shows the assembled slatted base being tilted, possibly for placement or transport.

Diagram Description: Shows the hex key being used to fasten the central support rails. A separate illustration depicts the entire slatted base being maneuvered.

Step 7: Final Frame Connections

Use screws (109049) and washers (100823) for final connections to secure the frame components. A magnified view shows the correct placement of the screw and washer. Crossed-out diagrams indicate incorrect placement.

Diagram Description: Shows the final securing of frame parts using screws and washers. Magnified views highlight correct and incorrect methods.

Step 8: Install Slatted Base

Place the fully assembled LÖNSET slatted bed base into the bed frame. An information icon (?) is displayed, suggesting important information or a tip.

Diagram Description: Shows the assembled slatted base being lowered into a bed frame.